Woods Equipment BW180XQ, BW126XQ manual BW126X and BW126XL Counterweight Installation

1.	Weight Box 750 lbs	9.	Spring Pin, 1/4 x 1-1/2
2.	Brace	10.	3/8 NC x 1-1/4 Hex Head Cap Screw
3.	Skid Shoe	11.	3/8 NC x 1-1/4 Self-Tapping Screw
4.	Mounting plate	12.	3/8 Flat Washer
5.	Sleeve, 1.25 x 1.5 x 3.40	13.	3/8 Lock Washer
6.	Hinge Pin	14.	3/8 NC Flanged Lock Nut
7.	Clevis Pin, 1 x 2.26	15.	1" Flat Washer
8.	1/4 x 1-1/2 Cotter Pin	16.	1 x 1-7/8 x 1/4 Washer

Figure 40. Counterweight Installation

BW126X and BW126XL Counterweight Installation

■The offset model is unstable without adequate counterweight. Use counterweight box loaded with 750 lbs. of steel.

CAUTION

Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.

This unit may be operated with only one wing - either right or left. With only one wing, the unit is unshielded and unstable. When electing to operate with one wing, you must install a counterweight box, available from your dealer. This box has a dual purpose: it substitutes for the shielding and for the weight of the removed wing.

The counterweight must be installed in the following sequence and will require at least two people. A floor jack or a suitable lifting device will be helpful to align the hinges when installing the hinge pin.

Refer to Figure 40.

1.Remove hinge pin (6) from center section.

MAN0962 (1/9/2012) Assembly 43