Woods Equipment BW126XQ, BW180XQ manual Install CV Drive Optional, Install Wing

Install CV Drive (Optional)

Before installing cutter input driveline to gearbox, check the tag wired to the driveline and the tag wired to the input shaft of gearbox. Ensure the tag rpm speeds match the rpm speed decal on front of cutter. After con- firming all speeds match, remove and discard tags and then complete driveline assembly.

1.Align hole in drive yoke with groove on gearbox input shaft and slide rear half of drive (23) onto shaft.

2.Secure with bolt and nut supplied with drive.

5. CV Drive

Figure 29. CV Drive Installation

Install Wing

CAUTION

Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.

6.	Side skid	80.	1/2 NC x 1 Crg Bolt
8.	Winglet	81.	1/2 NC x 1-1/2 Crg Bolt
15. Hinge Pin		88.	1/2 NC Flnge Lock Nut

64. Spring Pin 1/4 x 1-1/2 107. 1" Flat Washer

Figure 30. Right Wing Installation

Install Wing Cylinder & Lock-up Bar

The wing must be installed in the following sequence and will require at least two people. A floor jack or a suitable lifting device will be helpful to align decks when installing the hinge pin.

Check RPM tags on wing and center section to make sure they match before proceeding.

1.	Remove hinge pin (15) from center section.
2.	Place wing assembly adjacent to the center section
	and align hinge sections.
3.	Insert hinge pin through the hinge sections and
	secure with spring pin (64) and washer (107) on

4.Hydraulic Cylinder

16. Wing Lock-Up Bar

18. 1 x 4.08 Clevis Pin

19. Cylinder Link

20. Cylinder Link

21. Spacer, 3/4

22. Lock-Up Pin, 1 x 5

53. Spacer, 1"

54. 1 x 2.72 Clevis Pin

59.1/4 x 1/4 x 200" Hose

61.3/16 Safety Pin

62.1/4 x 1-1/2 Cotter Pin

69.1/4 x 1/4 Elbow w/Restrictor

90.1/2 x 1/4 Reducer Bushing

108. 1 x 1-7/8 Washer

	both ends.
4.	Attach side skid (6) to the wing using four carriage
	bolts (81) and flange lock nuts (88).
5.	Repeat procedure of opposite wing. (BW126XR
	only had right wing installed. BW126XL only has
	left wing installed.

Figure 31. Wing Cylinder & Lock-Up Bar Installation

1.Place two cylinder links (19 & 20) on either side of cylinder lug on center section as shown, align holes and insert clevis pin (18).

NOTE: Items 19 & 20 must be installed with square corners on top and facing cylinder as shown.

MAN0962 (1/9/2012) Assembly 37