Woods Equipment BW180XQ, BW126XQ manual Install Wheel and Hub, Install Tongue

Install Wheel and Hub

1.Insert wheel hub into outside of wheel yoke arm (1) and align holes.

2.Secure into position using cap screw (83) and flanged lock nut (88).

3.Attach wheel to hub using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75 lbs-ft. Check that tire air pressure is a maximum of 40 psi.

NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).

4.Install optional dual wheel and hub to inside of wheel yoke arm.

NOTE: Pneumatic (BW180X and BW180XQ only), notat, and airplane tires are available for this cutter. See page 67 for parts list.

1.Center Wheel Yoke Arm

83. 1/2" NC x 3" HHCS GR5

88. 1/2" NC Flange Lock Nut

Figure 26. Center Section Wheel and

Hub Installation

Install Tongue

1.Attach tongue (22) to center section using two tongue pivot pins (37) and cotter pins (60).

2.Attach attitude rod (6) to lug on tongue and secure with clevis pin (41), washer (107), and cotter pin (62).

3.Attach parking jack (21) to the side of the tongue.

4.Attach safety chain (8) to the bottom of center gusset and secure with cap screw (97), washer (100), and lock nut (102).

6.Attitude Rod

8.Safety Chain

21.Parking Jack

22.Tongue

37.Tongue Pivot Pin

41.Clevis Pin, 1" x 2.26"

60.3/16 x 1-1/2 Cotter Pin

62.1/4 x 1-1/2 Cotter Pin

97.3/4 NC x 2-1/4 Hex Head Cap Screw 100.3/4 x 2 x 3/8 Flat Washer

102.3/4 NC Lock Nut 107.1" Flat Washer

Figure 27. Tongue Installation

MAN0962 (1/9/2012) Assembly 35