Woods Equipment BW180XQ, BW126XQ Install 3-Joint Drive 540 RPM Only, Joint Drive Installation

Install 3-Joint Drive (540 RPM Only)

Before installing cutter input driveline to gearbox, check the tag wired to the driveline and the tag wired to the input shaft of gearbox. Ensure the tag rpm speeds match the rpm speed decal on front of cutter. After con- firming all speeds match, remove and discard tags and then complete driveline assembly.

1.Attach H-frame (30) to tongue with cap screw (93), sleeves (39), cup washers (94), and nut (95).

2.Coat splined end of gearbox input shaft with grease.

3.Align hole in drive yoke with groove on gearbox input shaft and slide drive (33) onto shaft.

4.Secure with bolt and nut supplied with drive.

5.Secure driveline carrier bearing to H-frame with cap screw (86), washer (87), sleeves (89) and a flanged lock nut (88).

NOTE: When cutting height is established, adjust the 3-joint H-frame bearing height so that the front driveline is parallel to the ground.

6.Attach front driveline (32) to rear driveline (33) and tighten clamp bolt and nut.

7.Attach shield (19) to driveline carrier bearing with two cap screws (76) and lock washers (77).

8.Attach spacer (38) to top hole of H-frame using cap screw (86) and flanged lock nut (88).

5. CV Drive

19.Carrier Bearing Shield

30.H-Frame

32.Front 2/3 of 3-Joint Drive

33.Rear Telescoping Shaft

38..66 x .88 x 4.50 Sleeve

39..625 x 1 x .563 HT Sleeve

76.3/8 NC x 1 Hex Head Cap Screw

77.3/8 Lock Washer

86.1/2 NC x 6-1/2 Hex Head Cap Screw

87.1/2 Flat Washer

88.1/2 NC Flange Lock Nut

89..50 x 1.00 x 1.031 Sleeve

93.5/8 NC x 7 Hex Head Cap Screw

94.5/8 x 1-3/4 x 14 GA Cup Washer

95.5/8 NC Hex Lock Nut

Figure 28. 3-Joint Drive Installation

36 Assembly MAN0962 (1/9/2012)