Yazoo/Kees ZEKW42170, ZEKW52210 manual Maintenance, Safety Instructions

Page 13
Maintenance

SAFETY INSTRUCTIONS

Maintenance

WARNING!

The engine must not be started when the driver’s floor plate or any protective plate for the mower deck’s drive belt is removed.

Safe Handling of Gasoline

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

Extinguish all cigarettes, cigars, pipes, and other sources of ignition.

Use only approved gasoline container.

Never remove gas cap or add fuel with the engine running. Allow engine to cool at least two (2) minutes before refueling.

Never fuel the machine indoors.

Never store the machine or fuel container where there is an open flame, spark, or pilot light such as on a water heater or other appliances.

Never fill containers inside a vehicle or on a truck or trailer bed with plastic liner. Always place containers on the ground away from your vehicle when filling.

8011-516

Never fill the fuel tank indoors

Before you begin refueling, minimize the risk of static electricity by touching a metal surface.

Remove gas-powered equipment from the truck or tailer and refuel it on the ground. If this is not possible, then refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

If fuel is spilled on clothing, change clothing immediately.

Never overfill fuel tank. Replace gas cap and tighten securely.

Do not start the engine near spilled fuel.

Never use gasoline as a cleaning agent.

If leaks arise in the fuel system, the engine must not be started until the problem has been resolved.

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling

English-11

Image 13
Contents Models Operator’s manual968999295/ZEKW42170 968999296/ZEKW52210Page OPERATOR’S MANUAL ContentsZE RIDER English-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead Safety Instructions SAFETY INSTRUCTIONSGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles IMPORTANT INFORMATION TransportCustomer responsibilities Controls CONTROLSControl Locations 2. Motion Control Levers 1. Parking BrakeTracking 4. Seat adjustment bolts3. Fuel Shut Off Valve 1. Forward5. Refueling 7. Fuses 6. By pass linkage8. Hour Meter 10. Ignition Switch9. Choke Control 11. Throttle Control 12. Blade switch13. Cutting height pedal AccessoriesOperation OPERATIONTraining Starting the Engine Before Starting6.Move the throttle to the middle position 8.Open the fuel shut off valve IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine the engine stopped Moving by Handthe ignition key has been removed the parking brake is onMaintenance MAINTENANCEMaintenance Schedule The ignition key has been removed The engine is stoppedThe parking brake is on Battery Ignition System Checking the Safety System Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake 2. Throttle cableStandard air filter Replacing the Air Filter Kawasaki EngineChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking Tire Pressures Checking the V-belts Checking the Parking BrakeDeck belt Faulty adjustment can cause an accidentDeck belt installation IZT belt Checking the Blades Blade replacement Adjusting the Mower Deck To adjust anti-scalprollers Caster Wheels Cleaning and WashingHardware Use protective glasses when cleaning and washingParking brake Tracking adjustmentTo adjust parking brake Mower is tracking to the rightLubrication LUBRICATIONLubrication Schedule ZE1. Front Wheel Mount Lubricating the Cables2. Front Wheel Bearings 3. Deck spindle4. Deck outer spindle Checking the Oil Level Transaxle Transmission Fluid Change 6. Changing the Engine Oil Filter14.Proceed to the purge procedure Purging Procedures Trouble Shooting Guide TROUBLE SHOOTING GUIDEWater in the fuel Uneven mowing results STORAGE ServiceStorage Winter StorageWiring diagram WIRING DIAGRAMS1 13 11 5 12 Technical Data TECHNICAL DATAEquipment Overall dimensionsProductivity Torque Specifications Conformity Certificates CONFORMITY CERTIFICATESUSA requirements Service Journal SERVICE JOURNALDelivery Service 1. Change engine oil After the First 5-8HoursEnglish-69 4.Check battery with cables 25-HourService5.Lubricate according to lubrication chart 6.Check/clean the engine’s cooling air intake1.Perform the 25-hourservice 50-HourService4.Lubricate according to lubrication chart 5.Check/adjust the parking brake2.Perform the 50-hourservice 100-HourService4.Clean/replace the spark plugs 3.Change the engine oil filter300-HourService At Least Once Each Year English-75 English-76 English-77