MAINTENANCE
Parking brake
To adjust parking brake
Jack up unit and support properly with jack stands. Allow clearance to work at rear transaxles. Before making any adjustments:
Set park brake.
Measure the distance between the rod swivel pin and the brake arm washer. With the brake engaged, there should be a gap of 1/8” to 1/2” (3 mm to 13 mm) between the swivel pin and the brake arm washer.
If measurement is out of range adjust as follows:
Disengage park brake lever. Remove retaining clip and remove brake arm by pulling horizontally from the IZT splined shaft.
Rotate brake arm on spline “rearward” to increase brake tension. Rotate the brake arm one spline “forward” to decrease brake arm tension.
Reinstall the retaining clip and recheck gap between rod swivel pin and brake rod washer. Repeat the procedure on the other IZT.
Tracking adjustment
If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (1 bar). If the unit will not track straight, follow the steps below. Tracking must be checked on a flat and level concrete or blacktop surface.
Mower is tracking to the right.
Increase the air pressure
Mower is tracking to the left.
Increase the air pressure
Recheck tracking and keep making adjustments with the tire pressure until the unit tracks straight.
DO NOT exceed maximum recommended tire pressure 24 psi (1.6 bar).
Record the tire pressure for future reference.
3 | 2 | 1 |
|
1.Gap 1/8” to 1/2” between swivel and washer
2.Retaining clip
3.Brake arm
Park brake