Yazoo/Kees ZEKW42170, ZEKW52210 manual To start an engine with a weak battery, Operation

Page 31
To start an engine with a weak battery

OPERATION

To start an engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "Battery" in "Maintenance" section).

If “jumper cables“ are used for emergency starting, follow this procedure:

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower battery to start other vehicles. Do not allow vehicles to touch when using jumper cables.

To attach jumper cables

• Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully

charged battery.

8011-642

 

Jumper cables connection

Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

English-29

Image 31
Contents 968999296/ZEKW52210 Operator’s manualModels 968999295/ZEKW42170Page OPERATOR’S MANUAL ContentsZE RIDER English-2 General INTRODUCTIONIntroduction CongratulationsManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead Safety Instructions SAFETY INSTRUCTIONSGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles IMPORTANT INFORMATION TransportCustomer responsibilities Controls CONTROLSControl Locations 2. Motion Control Levers 1. Parking Brake1. Forward 4. Seat adjustment boltsTracking 3. Fuel Shut Off Valve5. Refueling 7. Fuses 6. By pass linkage8. Hour Meter 10. Ignition Switch9. Choke Control 11. Throttle Control 12. Blade switch13. Cutting height pedal AccessoriesOperation OPERATIONTraining Starting the Engine Before Starting6.Move the throttle to the middle position 8.Open the fuel shut off valve IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine the parking brake is on Moving by Handthe engine stopped the ignition key has been removedMaintenance MAINTENANCEMaintenance Schedule The ignition key has been removed The engine is stoppedThe parking brake is on Battery Ignition System Checking the Safety System 2. Throttle cable Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Checking the Engines Cooling Air IntakeStandard air filter Replacing the Air Filter Kawasaki EngineChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking Tire Pressures Faulty adjustment can cause an accident Checking the Parking BrakeChecking the V-belts Deck beltDeck belt installation IZT belt Checking the Blades Blade replacement Adjusting the Mower Deck To adjust anti-scalprollers Use protective glasses when cleaning and washing Cleaning and WashingCaster Wheels HardwareMower is tracking to the right Tracking adjustmentParking brake To adjust parking brakeZE LUBRICATIONLubrication Lubrication Schedule3. Deck spindle Lubricating the Cables1. Front Wheel Mount 2. Front Wheel Bearings4. Deck outer spindle Checking the Oil Level Transaxle Transmission Fluid Change 6. Changing the Engine Oil Filter14.Proceed to the purge procedure Purging Procedures Trouble Shooting Guide TROUBLE SHOOTING GUIDEWater in the fuel Uneven mowing results Winter Storage ServiceSTORAGE StorageWiring diagram WIRING DIAGRAMS1 13 11 5 12 Technical Data TECHNICAL DATAEquipment Overall dimensionsProductivity Torque Specifications Conformity Certificates CONFORMITY CERTIFICATESUSA requirements Service Journal SERVICE JOURNALDelivery Service 1. Change engine oil After the First 5-8HoursEnglish-69 6.Check/clean the engine’s cooling air intake 25-HourService4.Check battery with cables 5.Lubricate according to lubrication chart5.Check/adjust the parking brake 50-HourService1.Perform the 25-hourservice 4.Lubricate according to lubrication chart3.Change the engine oil filter 100-HourService2.Perform the 50-hourservice 4.Clean/replace the spark plugs300-HourService At Least Once Each Year English-75 English-76 English-77