Yazoo/Kees ZEKW42170, ZEKW52210 manual Operating on hills, Operation, Important Information

Page 33
Operating on hills

OPERATION

In order, for example, to turn right while moving forward, move the right control towards the neutral position. The rotation of the right wheel is reduced and the machine turns to the right.

Turning on the spot can be achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position.

Operating on hills

Read the"Driving on Slopes" in the "Safety Instruction" section.

WARNING!

Do not drive up or down hills with slopes greater than 10 degrees. And do not drive across any slopes.

The slowest speed possible should be used before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the park brake.

IMPORTANT INFORMATION

Control levers return to neutral when released. This may cause the mower to suddenly stop.

To restart movement, release the park brake.

Pull the control levers back to the center of the mower and press forward to regain forward motion.

Make all turns slowly.

8011-772

Stopping conditions

8011-711

Released parking brake

English-31

Image 33
Contents Models Operator’s manual968999295/ZEKW42170 968999296/ZEKW52210Page Contents OPERATOR’S MANUALZE RIDER English-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead SAFETY INSTRUCTIONS Safety InstructionsGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles IMPORTANT INFORMATION TransportCustomer responsibilities CONTROLS ControlsControl Locations 2. Motion Control Levers 1. Parking BrakeTracking 4. Seat adjustment bolts3. Fuel Shut Off Valve 1. Forward5. Refueling 7. Fuses 6. By pass linkage10. Ignition Switch 8. Hour Meter9. Choke Control 11. Throttle Control 12. Blade switch13. Cutting height pedal AccessoriesOPERATION OperationTraining Starting the Engine Before Starting6.Move the throttle to the middle position 8.Open the fuel shut off valve IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine the engine stopped Moving by Handthe ignition key has been removed the parking brake is onMAINTENANCE MaintenanceMaintenance Schedule The engine is stopped The ignition key has been removedThe parking brake is on Battery Ignition System Checking the Safety System Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake 2. Throttle cableStandard air filter Replacing the Air Filter Kawasaki EngineReplacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the V-belts Checking the Parking BrakeDeck belt Faulty adjustment can cause an accidentDeck belt installation IZT belt Checking the Blades Blade replacement Adjusting the Mower Deck To adjust anti-scalprollers Caster Wheels Cleaning and WashingHardware Use protective glasses when cleaning and washingParking brake Tracking adjustmentTo adjust parking brake Mower is tracking to the rightLubrication LUBRICATIONLubrication Schedule ZE1. Front Wheel Mount Lubricating the Cables2. Front Wheel Bearings 3. Deck spindle4. Deck outer spindle Checking the Oil Level Transaxle Transmission Fluid Change 6. Changing the Engine Oil Filter14.Proceed to the purge procedure Purging Procedures Trouble Shooting Guide TROUBLE SHOOTING GUIDEWater in the fuel Uneven mowing results STORAGE ServiceStorage Winter StorageWIRING DIAGRAMS Wiring diagram1 13 11 5 12 Technical Data TECHNICAL DATAOverall dimensions EquipmentProductivity Torque Specifications CONFORMITY CERTIFICATES Conformity CertificatesUSA requirements SERVICE JOURNAL Service JournalDelivery Service After the First 5-8Hours 1. Change engine oilEnglish-69 4.Check battery with cables 25-HourService5.Lubricate according to lubrication chart 6.Check/clean the engine’s cooling air intake1.Perform the 25-hourservice 50-HourService4.Lubricate according to lubrication chart 5.Check/adjust the parking brake2.Perform the 50-hourservice 100-HourService4.Clean/replace the spark plugs 3.Change the engine oil filter300-HourService At Least Once Each Year English-75 English-76 English-77