Jumpstarting, Tires | Yard-Man 131734G, 131704G, 131704F guide

lubricant is available, Order part number 737-0170. Engine oil may also be used,

When replacing blades, be sure to install the blade with the side of the blade marked "Bottom" (or with part number) facing the ground when the mower is in the operating position.

Blade Mounting Torque

3/8" Dia. Bolt 375 in, lb. min., 450 in. lb. max. 5/16" Dia. Bolt 150 in. lb. min., 250 in, lb. max,

To insure safe operation of your unit, all nuts and bolts must be checked periodically for correct tightness.

MAINTENANCEOF BATTERY

1.Check electrolyte level periodically (at least every two weeks). Keep the level to the split rings. Use only distilled water or a good quality drinking water. Never add acid or any other chemicals to the bat- tery after initial activation.

2.The battery should be checked with a hydrometer after every 25 hours of operation. If the specific gravity is less than 1 .225, the battery should be recharged. For Model 704F, maximum charge rate 5 AMPS.

3.Coat the terminals and exposed wire with a thin coat of grease or petroleum jelly for longer service and protection against corrosion.

4.The battery should be kept clean. Any deposits of acid should be neutralized with soda and water. Be careful not to get this solution in the cells.

5.Avoid tipping the battery. Even a "sealed" battery will leak electrolyte when tipped.

STORAGEOF THE BATTERY

1.Charge battery using normal methods. NEVER store discharged battery as it will not recover.

2.When storing battery for extended periods, discon- nect battery cables. Removing battery from unit is recommended.

3.Store in cold, dry place.

4.Recharge battery whenever the specific gravity is less than 1.225, before returning to service, or every two months, whichever occurs first.

COMMONCAUSESFOR BATTERYFAILURE

1.Overcharging

2.Undercharging

3.Lack of water

4.Loose hold downs and/or corroded connections

5.Excessive loads

6.Battery electrolyte substitutes

7.Freezing of electrolyte

NOTE: These failures do not constitute warranty.

BATTERYREMOVALOR INSTAllATION

WARNING: When removing the battery, follow this order of disassembly to prevent your wrench from shorting against thefram

1.Remove the Negative cable.

2.Remove the Positive cable.

To install a battery:

1.Attach the Positive cable.

2.Attach the Negative cable.

JUMPSTARTING

1.Attach the first jumper cable from the Positive ter- minal of the good battery to the Positive terminal of the dead battery.

2.Attach the second jumper cable from the Negative terminal of the good battery to the FRAME OF THE UNIT WITH THE DEAD BATTERY.

AWARNING: Failure to use this starting pro- cedure could cause sparking, and the gases in either battery could explode.

TIRES

Recommended operating tire pressure is approximately 12 p.s.i. (check sidewall of tire for tire manufacturer's recommended pressure). Maximum tire pressure under any circumstances is 30 p.s.i. Equal tire pressure should be maintained on all tires.

When installing a tire to the rim, be certain rim is clean and free of rust. Lubricate both the tire and rimgen

Never inflate to over 30 p.s.i. to seat beads.

WARNING: Excessive pressure (over 30p.s. when seating beads may causetire/r assembly to burst with force suf-

ficient to cause serious injury.

DECKBELTREPLACEMENT

When replacing the deck belt, disconnect the spring from transaxle, inside the right rear wheel (step 5). Refer to the separate deck manual packed with your

unit.

DRIVE BELT REPLACEMENT

MODEL 704F (See Figure 22)

1.Depress the clutch pedal and set parking brake.

2.Remove the deck from the lawn tractor.

3.Raise and block the front wheels of the lawn trac- tor so you can work under it.

4.Remove the transmission panel, and unhook the spring from the rear idler pulley.

131734G, 131704F, 131704G specifications

The Yard-Man 131704F, 131704G, and 131734G are standout models in the extensive lineup of lawn and garden equipment offered by Yard-Man, a brand known for its commitment to quality and innovation in outdoor power tools. These models cater primarily to homeowners and professional landscapers, providing robust solutions for maintaining lawns and gardens effectively.

One of the main features of the Yard-Man 131704F is its reliable engine performance. Powered by a potent motor, this model is designed to tackle both small and large areas with ease, ensuring a uniform cut and enhancing the appearance of your lawn. The 131704G variant similarly boasts a powerful engine, but the notable feature here is its focus on fuel efficiency. This model integrates advanced technology to optimize fuel consumption without compromising cutting power, making it an environmentally friendly choice.

The Yard-Man 131734G distinguishes itself with its cutting-edge features, including a multi-height adjustment system. Users can easily modify the cutting height to suit various grass types and seasonal conditions. This flexibility allows for tailored lawn care, ensuring that the grass remains healthy and vibrant throughout the year. Moreover, this model often includes a large grass catcher, which minimizes the need for raking and promotes a cleaner mowing experience.

In terms of durability, all three models come equipped with robust construction materials that ensure longevity and resistance to the elements. The decks are typically made from durable steel, which provides stability and strength, while the ergonomic designs make them user-friendly, reducing fatigue even during extended use.

Safety features are also paramount in these Yard-Man models. Each is equipped with safety guards and easy-start mechanisms that enhance the user experience, allowing homeowners and professionals alike to operate the equipment with confidence.

In summary, the Yard-Man 131704F, 131704G, and 131734G present an excellent combination of performance, efficiency, and user-friendly design. Their exceptional engine capabilities, cutting height adjustments, and durable construction make them ideal for anyone looking to maintain a pristine lawn or garden. Whether for personal use or professional landscaping, these models represent a solid investment in outdoor maintenance equipment.