Servis-Rhino 60C manual Equipment Operation Safety Instructions and Practices

Page 10
(SG-12)
(SG-10)
(SBH-41)
(SBH-29)
(SBH-21)

SAFETY

SAFETY

Make sure the hydraulic quick disconnects are fully seated into the connections. Do not use the Backhoe if the hydraulic connection is leaking. Leaking oil could allow the Backhoe to fall resulting in a serious crushing injury.

Make sure all air is purged from the hydraulic system before using the Backhoe. Air in the system can cause the Backhoe to respond sluggishly or with unexpected movement. The air can be purged from the cylinder lines by fully cycling the cylinders several times from the fully closed to fully open position. Sudden or unexpected movement or dropping of the Backhoe and attachment could result in serious injury.

Never interfere with factory-set hydraulic calibrations. Any change in calibration could cause a failure of the equipment and may result in injury. (SBH-13)

Backhoe mounting bolts and nuts must be kept tightened. Retighten the bolts and nuts after the first 10 minutes of operation, and every 8 hours after that. (SBH-39)

Do not lean over controls. Engage and disengage the boom and stabilizer transport locks and the swing lock pin with the engine off. Do not operate the backhoe control from outside of the operator’s area. (SBH-40)

Equipment Operation Safety Instructions and Practices

Do not use the backhoe hydraulic control levers as grab handles. Activation of the control levers can cause unexpected movement of the boom, arm, bucket or stabilizers. Always enter and exit the backhoe from the ground using the steps and grab handles.

Operate the tractor only while seated in the tractor seat with the seatbelt fastened. Operate the backhoe only while seated in the backhoe seat. (SBH-19)

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

Do not mount or dismount the Tractor while the tractor is moving. Mount the Tractor only when the Tractor and all moving parts are completelystopped.

F-4139 01/11

Safety Section 1-6

© 2011 Alamo Group Inc.

Image 10
Contents 60C To the OWNER/OPERATOR/DEALER Table of Contents Page Safety Section Safety SG-4 Safety Safety Equipment Operation Safety Instructions and Practices Safety Safety Safety SBH-1 Transporting Safety Instructions and Practices Safety Storage Safety Instructions and Practices Parts Information See Your Rhino DealerDecal Location QTY Level Description Decal Description 4139 01/11 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Bucket Data General DataCylinder Data Introduction Operation Section Engine Speed PRE-OPERATION ChecklistOperating Directions ControlsRight Hand Stabilizer Left Hand StabilizerOperating Backhoe Dumping Bucket Filling BucketTrenching Between a Building & Open Excavators Opposite side of the trenches Side Slope Excavating or TrenchingBackfilling Seat AdjustmentMiscellaneous Finishing Straight WallsBoom Lock Mounting and Dismounting BucketsPlacing the Stabilizers Stabilizer LockTransporting the Backhoe Removal from Tractor StorageMaintenance Section Cylinder Disassembly Cylinder ServiceCylinder Assembly Hydraulic Hoses Beginning of SeasonHydraulic System Reservoir Tightening Nuts and Bolts Lubrication ChartBucket Tooth Points LubricationHydraulic Troubleshooting Maintenance Spool Seal Installation Valve ServiceMain Relief Replacement Torque SettingsMaintenance Parts List Description QTYProper Torque for Fasteners Page Rhino Required of the Owner 60C-SOM-01/11 F-4139C Printed U.S.A