Servis-Rhino 60C manual Miscellaneous, Backfilling, Seat Adjustment, Finishing Straight Walls

Page 34

OPERATION

OPERATION

MISCELLANEOUS

When finishing straight walls or bell holes in sandy soil, use a platform under the rear tires and stabilizers. The platform distributes the load over a larger area and lessens the possibility of a cave-in. The platform also tends to keep the unit from creeping rearward if hard digging is encountered.

BACKFILLING

Backfill by lifting the bucket over the spoil pile and then crowding in. Pull both the crowd and lift levers for smooth, even backfilling.

IMPORTANT: Do not backfill by using the swing circuit and dragging the bucket sideways. Doing so can cause damage to the dipstick, boom, swing cylinders, or mainframe.

SEAT ADJUSTMENT

To adjust seat up or down, remove clevis pin (1) and hair pin (2) which secures seat bracket (3) to seat post (4) and raise or lower the seat. Adjust seat forward or rearward by repositioning seat on mounting plate (5).

FINISHING STRAIGHT WALLS

Finish the far wall by crowding out while forcing the bucket down with the bottom. Actuate the bucket (curl out) to keep the bottom of the bucket vertical.

To finish the rear wall, lift up and crowd in. Keep the edges of the bucket horizontal.

OPTIONAL SWIVEL SEAT MECHANISM

Refer to instruction sheet provided with swivel mechanism for installation and operation instructions.

F-4139 01/11

Operation Section 3-6

© 2011 Alamo Group Inc.

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 60C To the OWNER/OPERATOR/DEALER Table of Contents Page Safety Section Safety SG-4 Safety Safety Equipment Operation Safety Instructions and Practices Safety Safety Safety SBH-1 Transporting Safety Instructions and Practices Safety Storage Safety Instructions and Practices Parts Information See Your Rhino DealerDecal Location QTY Level Description Decal Description 4139 01/11 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Bucket Data General DataCylinder Data Introduction Operation Section Engine Speed PRE-OPERATION ChecklistOperating Directions ControlsRight Hand Stabilizer Left Hand StabilizerOperating Backhoe Dumping Bucket Filling BucketTrenching Between a Building & Open Excavators Opposite side of the trenches Side Slope Excavating or TrenchingBackfilling Seat AdjustmentMiscellaneous Finishing Straight WallsBoom Lock Mounting and Dismounting BucketsPlacing the Stabilizers Stabilizer LockTransporting the Backhoe Removal from Tractor StorageMaintenance Section Cylinder Disassembly Cylinder ServiceCylinder Assembly Hydraulic Hoses Beginning of SeasonHydraulic System Reservoir Tightening Nuts and Bolts Lubrication ChartBucket Tooth Points LubricationHydraulic Troubleshooting Maintenance Spool Seal Installation Valve ServiceMain Relief Replacement Torque SettingsMaintenance Parts List Description QTYProper Torque for Fasteners Page Rhino Required of the Owner 60C-SOM-01/11 F-4139C Printed U.S.A
Top Page Image Contents