Servis-Rhino 60C Mounting and Dismounting Buckets, Placing the Stabilizers, Boom Lock, Swing Lock

Page 35

OPERATION

MOUNTING AND DISMOUNTING BUCKETS

Mount buckets using 1 x 6-5/8 anti-rotation pins (1), 5/16 x 2” cap screws (2) and lock nuts (3).

PLACING THE STABILIZERS

Set the stabilizers to remove weight from the rear wheels. Rear wheels are to remain touching the ground as this provides for the widest stabilizer stance and lowest center of gravity.

Raising the wheels off the ground will not only reduce stability and digging depth, but impair performance and impose unnecessary stress on the backhoe and tractor.

BOOM LOCK

Use boom lock when transporting backhoe.

1.Completely raise boom and lower dipperstick.

2.Secure boom using boom lock bracket.

STABILIZER LOCK

Use stabilizer lock when transporting backhoe.

1.Completely raise stabilizers.

2.Secure each stabilizer using stabilizer lock brackets.

OPERATION

SWING LOCK

Use swing lock when transporting or dismounting backhoe.

Position boom straight back and drop pin through holes in swing frame and mainframe. Store pin in bushing provided on mainframe.

F-4139 01/11

Operation Section 3-7

© 2011 Alamo Group Inc.

Image 35

Contents 60C To the OWNER/OPERATOR/DEALER Table of Contents Page Safety Section Safety SG-4 Safety Safety Equipment Operation Safety Instructions and Practices Safety Safety Safety SBH-1 Transporting Safety Instructions and Practices Safety Storage Safety Instructions and Practices See Your Rhino Dealer Parts InformationDecal Location QTY Level Description Decal Description 4139 01/11 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Cylinder Data General DataBucket Data Introduction Operation Section Controls PRE-OPERATION ChecklistOperating Directions Engine SpeedOperating Backhoe Left Hand StabilizerRight Hand Stabilizer Trenching Between a Building & Open Excavators Filling BucketDumping Bucket Side Slope Excavating or Trenching Opposite side of the trenchesFinishing Straight Walls Seat AdjustmentMiscellaneous BackfillingStabilizer Lock Mounting and Dismounting BucketsPlacing the Stabilizers Boom LockRemoval from Tractor Storage Transporting the BackhoeMaintenance Section Cylinder Assembly Cylinder ServiceCylinder Disassembly Hydraulic System Reservoir Beginning of SeasonHydraulic Hoses Lubrication Lubrication ChartBucket Tooth Points Tightening Nuts and BoltsHydraulic Troubleshooting Maintenance Torque Settings Valve ServiceMain Relief Replacement Spool Seal InstallationMaintenance Description QTY Parts ListProper Torque for Fasteners Page Rhino Required of the Owner 60C-SOM-01/11 F-4139C Printed U.S.A