Scotts S1642, S1742, S2046 Adjusting Brakes - Automatic Hand Control, Service Steering And Brakes

Page 38

Adjusting Brakes - Automatic Hand Control

SERVICE STEERING AND BRAKES

A

C

D

FB B

D

•Brake disc (A) is contacting the case (B),

AND/OR

•Brake lever (C) is contacting its mounting bracket (D), top or bottom.

If so, REPLACE friction pucks and brake disc BEFORE making adjustment. (See you Authorized Service Center.)

3.Block the front and rear wheels, and release the parking brake.

E

G

F

H

4.From the rear of the tractor, locate the brake disc (E), lock nut (F), and friction puck (G).

5.Insert a 0.25 mm (0.010 in.) shim gauge (H) between the disc and friction puck. The shim should slide with slight interference.

IF THE SHIM WILL NOT FIT:

•Loosen lock nut (F) until the shim slides in. Tighten the lock nut until the shim has slight interference.

•Remove the shim and cycle the brake pedal. Readjust if needed.

IF THE SHIM SLIDES FREELY:

•Install the shim and tighten lock nut (F) until there is slight interference.

•Remove the shim and cycle the brake pedal. Readjust if needed.

Adjusting Brakes - Automatic Hand Control

CAUTION: Avoid injury! Before adjusting

brakes: STOP engine. Remove key. Wait for all moving parts to STOP.

1.Park tractor on flat, level surface. STOP engine, turn key to the OFF position, and remove key.

2.UNLOCK the park brake and release brake pedal.

E

A

	B				C
	B				C

3.Measure distance from inside of brake rod stop tabs (A) to outside of compression spring bracket (B) (located below foot tread area on left-hand side of transmission). Distance

(C) should be 2 – 10 mm (0.08 – 0.40 in).

Service Steering and Brakes - 34

Image 38

Contents S1642, S1742, and S2046 OPERATOR’S MANUALScotts Lawn Tractors OMGX10784 C0CALIFORNIA Proposition 65 Warning INTRODUCTIONTHANK YOU for purchasing a Scotts product PRODUCT IDENTIFICATION Record Identification NumbersIdentify Parts ASSEMBLYConnect and Check Battery 42-Inch Mowers OnlyChecking Tire Pressure Machine Safety Labels SAFETY SIGNSSafety-Alert Symbol Certification Emission Control System Certification LabelEmission Compliance Period THROWN OBJECTSTractor Controls - Automatic CONTROLSTractor Controls - Gear Park Safely OPERATING MACHINEOperate Safely Wear Appropriate Clothing Adjusting SeatAvoid Tipping Transport SafelyUsing the Park Brake Starting EngineWarming and Idling Engine Using Throttle ControlCold Weather Starting Tips On Automatic TransmissionStopping Engine Using Travel Controls - GearUsing Travel Controls - Automatic CAUTION Avoid injuryUsing Cruise Control DISENGAGE CRUISE CONTROL Using Reverse Implement OptionENGAGE CRUISE CONTROL Pushing Machine Daily Operating ChecklistTesting Safety Systems TestTest IMPORTANT Avoid damage! On Automatic Avoid Using Ground Engaging Equipment Using Front WeightsUsing Rear Wheel Weights Using Tire ChainsOPERATING MOWER Using Lift Lever to Raise and Lower MowerAdjusting Cutting Height Operate Mower SafelyCAUTION Avoid injury! Before you adjust gage Adjusting Mower Gage WheelsAdjusting Mower Level Side-to-Side CAUTION Avoid injury! Before you adjustAdjusting Mower Level Front-to-Rear Engaging and Disengaging MowerUsing Mower Deck Side Discharge - 42-Inch Mower Decks Dismounting to Inspect or Unplug Mower or Optional BaggerUsing Mower Deck Mulch Ready - 42-Inch Mower Decks Using Mower Deck with Optional Equipment - 42-Inch Mower DecksA must be removed 1. Remove mulch cover Lift plastic discharge chute John Deere Quality REPLACEMENT PARTSService Literature Parts for 42-Inch Mower Deck Parts for 46-Inch Mower DeckHandling Waste Product and Chemicals SERVICE MACHINE SAFELYPractice Safe Maintenance SERVICE INTERVAL CHART Service IntervalsDATE Service RecordSERVICE PERFORMED Adjusting Carburetor SERVICE ENGINEEngine Warranty Maintenance Statement Make sure engine is COLD when checking engine oil levelChanging Engine Oil and Filter CAUTION Avoid injury! Engine may be hot, be careful not to burn handsNOTE DO NOT wash paper element Checking and Cleaning Air Cleaner Elements - S1642 and S1742S1742S1642 Checking and Cleaning Air Cleaner Elements - S2046 Checking Spark Plugs Replacing Fuel FilterIMPORTANT Avoid damage! To avoid overheating Clean Air Intake Screen and EngineNOTE Change filter when fuel is low in fuel tank Grease SERVICE STEERING AND BRAKESAdjusting Brakes - Gear Lubricating Front Wheel Spindles, Wheel Bearings and Axle PivotAdjusting Brakes - Automatic Hand Control Adjusting Brakes - Automatic Foot Control G D FMower Spindles SERVICE MOWERAdjusting Mower Belt Tension Replacing Mower Drive BeltAdjusting Spindle Brake M88119b Servicing Mower BladesChecking Mower Blades E C D B A CD B AE D C B A Sharpening Blades Balancing BladesClean Battery and Terminals SERVICE ELECTRICALChecking the Battery Removing and Installing the BatteryCharging the Battery Using Booster Battery Replacing Headlight BulbMX1535 Replacing FuseM88559 SERVICE MISCELLANEOUS FuelOctane Rating Using Clean FuelsUsing Fresh Fuel and Stabilizers Fuel BlendsM96452 Care for Plastic and Painted SurfacesPAINTED METAL SURFACES SERVICE MISCELLANEOUS REMOVING MOWER Removing MowerREMOVING MOWER INSTALLING MOWER Installing MowerQ P O N Engine TROUBLESHOOTINGUsing Troubleshooting Chart TROUBLESHOOTING Mower Electrical Preparing Machine for Storage STORING MACHINEStoring Safely Preparing Engine For StorageNOTE The stored battery should be recharged every 90 days Removing Machine From StorageModel S1742 SPECIFICATIONSModel S1642 Model S2046Fuel All Models Dimensions All ModelsElectrical System All Models Tires All ModelsRecommended Lubricants Mower Deck 42-InchMower Deck 46-Inch EQUIPMENT USE WARRANTYWARRANTY TERMOwner’s Warranty Responsibilities Your Warranty Rights and ObligationsJohn Deere Emission Control System Warranty Coverage Length Of Warranty CoverageMaintenance Warranty Coverage NOTE Applicable in North America onlyWarranty Service And Charges Consequential Warranty CoverageWarranty Code Warranty PeriodINDEX INDEX Step Please do not return this tractor to the store where you purchased itQUALITY STATEMENT