SERVICE ELECTRICAL
2. | Connect positive (+) charger cable to positive (+) battery |
terminal. | |
3. | Connect negative |
battery terminal. | |
4. | Plug in charger cord. |
5. | Charge battery using a 12 Volt battery charger at a rate |
of |
CAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode:
•DO NOT attempt to jump start a frozen battery. Warm to 16 degrees C (60 degrees F).
•DO NOT smoke near battery.
•Wear eye protection and gloves.
•Keep sparks and flames away.
•DO NOT connect the negative
F
2 hours. | |
6. | Unplug charger cord. Remove charger cables. |
7. | Install battery. (See Removing and Installing Battery in |
this section.) |
Using Booster Battery
D |
B |
E | C |
| A |
A- Booster Battery
B- Disabled Vehicle Battery
1.Connect positive (+) booster cable to booster battery (A) positive (+) post (C).
2.Connect the other end of positive (+) booster cable to the disabled vehicle battery (B) positive (+) post (D).
3.Connect negative
4.Connect the other end (F) of negative
5.Start the engine of the disabled machine and run machine for several minutes.
6.Carefully disconnect the booster cables in the exact reverse order: negative cable first and then the positive cable.
Replacing Headlight Bulb
1. Lift hood.
Service Electrical - 43