North Star M165939J owner manual Power Load Planning & Management, Example conversion to watts

Page 11

Power Load Planning & Management

WARNING

NEVER exceed the rated wattage capacity of your generator.

OVERLOADING may cause SERIOUS DAMAGE to the generator and attached electrical devices, and may result in fire.

Your generator MUST BE SIZED PROPERLY to provide both the running and starting (surge) wattage of the devices you will be powering. Before using your generator, determine the running and starting wattage requirements of all the electrical devices you will be powering simultaneously. The sum of the running and starting wattages of the devices being powered must not exceed the continuous output rating of your generator. (The continuous output rating of your generator is listed in the “Specifications” section of this manual.) Note that:

Devices without electric motors such as light bulbs, radios, and televisions have the same running and starting wattage.

Devices with electric motors such as refrigerators, compressors, and hand tools typically require a starting wattage that is 3 to 5 times greater than the running wattage.

The running and starting wattage requirements are often listed on a device’s nameplate. If wattage is not given on the device’s nameplate, the wattage may be calculated by multiplying the nameplate voltage by nameplate amperage, Watts = Volts X Amps.

Example conversion to watts:

120 Volts X 5 Amps = 600 Watts

If only the running voltage is given on the nameplate for a device with an electric motor, the starting wattage can be approximated to be three to five times the running wattage.

Estimates for the running wattage requirements for common devices are listed in Table 1 below. Guidance for starting wattages is provided in the table’s footnotes.

Table 1

 

Running

 

Running

Device

Watts

Device

Watts

Air conditioner (12.000 BTU)

1700 (a,b)

Jet pump

800 (a)

Battery charger (20 Amp)

500

Lawn mower

1200

Belt sander (3”)

1000

Light bulb (100 Watt)

100

Chain saw

1200

Microwave oven

700

Circular saw (6½”)

2000 (a,b)

Milk cooler

1100 (a)

Coffee maker

1800 (a,b)

Oil burner on furnace

300

Compressor (1 HP)

1400 (a,b)

Oil-fired space heater (140,000 Btu)

400

Compressor (3/4 HP)

1800 (a)

Oil-fired space heater (85,000 Btu)

225

Compressor (1/2 HP)

1400 (a)

Oil-fired space heater (30,000 Btu)

150

Curling iron

700

Oven

4500

Dishwasher

1200

Paint sprayer, Airless (1/3 HP)

600 (a)

Edge trimmer

500

Paint sprayer, Airless (handheld)

150

Electric nail gun

1200

Radio

200

Electric range (1 element)

1500

Refrigerator

600 (b)

Electric skillet

1250

Slow cooker

200

11

Image 11
Contents M165939J Hazard Signal Word Definitions Table of Contents About Your Generator About Your GeneratorRead this Manual About Your Generator cont’dSpecifications Item #165939J SpecificationsPart numbers Description Safety Label Locations Item #165939JDescription Machine Component Identification Item #165939JReference Guide Reference 13 120V, 20A, Duplex Example conversion to watts Power Load Planning & ManagementTotal 6275W Power Load Planning & Management cont’dUnpacking & Delivery Inspection Installation / Initial Set-UpPlanning the Power Load Gas Hook-up Installation for Natural Gas or LPG if needed Installation / Initial Set-Up Set-up either as a Building BACK-UP or Portable Power Source Generator Current/Power Maximum Extension Cord Length Select a Suitable Site Structure allow at least a 7’ clearance Grounding the generator Battery Installation Operation General safety rules for operationOperation cont’d Operation cont’d Manual Preparing for OperationOperation cont’d Natural Gas Start LPG/NG supply If usingOperation cont’d Starting the Engine Using LP/NG To start engine using LP or Natural GasTo start engine using gasoline Checking Generator Output Connecting Loads Stopping Switching Fuels during operationStop the engine using the following steps Storage & Exercise When you are finished using the generator, you mustOperation cont’d Maintenance & Repair Maintenance & RepairMaintenance & Repair cont’d Troubleshooting TroubleshootingSummary of Importation Information for Operation Battery SafetySummary of Importation Information for Operation cont’d Installation / Initial Set-up SafetyPersonal protective equipment Know how to operate\Gasoline Safety Propane & Natural Gas SafetySafety During Use Safety After use Generator Exploded View Rev J Fig # Description Qty Wiring Diagram Rev J Diag # Description Qty Diag # Description Qty Fuel Delivery System Rev JRef # Description Qty Generator Head Exploded View Rev J