4Push in gas control knob and turn counter clockwise to "IGNITE" then to "PILOT" position, this will light the pilot. If needed, keep depressing and turning control knob counter clockwise until the pilot lights. (You will hear 1 clicking noise)
5.Once the pilot is lit, keep the control knob depressed for approx. 30 seconds. Then release the control knob.
6.If pilot does not stay lit, repeat steps 3 and 4 after 5 minutes.
7.If pilot still does not stay lit, proceed as follows:
a)Push in gas control knob and turn counter clockwise to the “PILOT” position.
b)Keep depressing the control knob, put a long stem lighter into the ignition hole on the emitter screen. To light the pilot.
c)Repeat step 5.
8.Push in and turn control knob counter clockwise to “HIGH” position, if you want a lower temperature, push in the control knob and turn clockwise to the “LOW” position.
9.Close base assembly door.
Flame Characteristic
The flame pattern at the emitter screen should be visually checked whenever heater is operated.
Normally the burner flame is blue, but little yellow flame is acceptable.
If flames extend beyond surface of the emitter grid ,
or the phenomena of flame lift or light back, or black spot is accumulating on the emitter grid or reflector, the heater should be turned off immediately. The heater should not be operated again until the unit is serviced and or repaired.
OPERATION |
12