Napoleon Fireplaces SRPT03-XXXX owner manual Hardware Used

Page 8

Step 3

Attach emitter screen (5) to burner column (3) using three M4 x 8 bolts (9)

Note: The ignition hole on emitter screen must line to the control knob.

Step 4

Attach reflector dome (6) to emitter screen (5) using six 6mm washers (12) and three M6 nuts (11).

Then attach dome cap (7) and decorative dome cap nut (8) to reflector dome (6).

	ASSEMBLY
Step 2
	Ignition
	Hole
ODS Hole	9
ODS Hole
	3

Hardware Used

9 M4 x 8 bolt

X 3

Step 4

8

7

11

12

12

5

Hardware Used

11	M6 nut	X 3
3	6mm Washer	X 6
12	6mm Washer	X 6

8

Image 8

Contents Tabletop Patio Heater Carbon Monoxide Hazard PrecautionsSpecification Precautions Precautions Preparation Tools Needed not IncludedParts List Assembly Hardware Used Regulator Check for leak Safety CheckDisconnected cylinder when storage or transportation Lighting instructions OperationBefore Lighting Flame Characteristic When heater is on Operation pressure checkedRe-light Shut down instructionsLocating Header for USE MAINTENANCE/STORAGE Cleaning and MaintenanceBetween uses During periods of extended inactivity or when transportingStorage Troubleshooting Problem Probable Cause SolutionONE-YEAR Limited Warranty SRPT03-XXXX