Multiquip operation manual DCA-800SSK GEN. START-UP Procedure Manual, Before Starting

DCA-800SSK — GEN. START-UP PROCEDURE (MANUAL)

Before Starting

CAUTION - LETHAL EXHAUST HAZARD

The engine's exhaust contains harmful emissions.

ALWAYS have adequate ventilation when operating. Direct exhaust away from nearby personnel.

If applicable perform the following:

■Apply commercial power to the internal battery charger receptacle (to ensure good starting) via commercial power. An external power cord will be required.This capability is an option.

■Apply commercial power to the jacket water heater receptacle (not necessary for warm climates) via commercial power.An external power cord will be required.This capability is an option.

Generator and Control Panel

WARNING - STARTINGTHE GENERATOR

NEVER! manually start the engine with the main, GFCI or auxiliary circuit breakers in the ON (closed) position.

1.Place the main,G.F.C.I. and aux. circuit breakers (Figure 42) in the “OFF” position prior to starting the engine.

Figure 42. Main, Aux. and GFCI

Circuit Breakers (OFF)

2.Connect the load to the UVWO terminals or auxiliary receptacles as shown in Figure 43. These load connection points can be found on the output terminal panel. To gain access to the UVWO terminals or other power receptacles, unlock the access cover and lift the door.

3.The UVWO terminals are protected by a plastic cover, remove this cover to gain access to the terminals. Tighten terminal nuts securely to prevent load wires from slipping out.

Steps 1 thru 19 are referenced

for Engine Operating Panel up

NOTEto S/N 3699247. See Figure 41 below.This panel has an igni- tion switch.

Figure 43. Load Connections

Figure 41. Engine Operating Panel	4. Close all engine enclosure doors (Figure 44).
Up To S/N 3699247

Figure 44. Engine Enclosure Doors

DCA-800SSK (STD) — OPERATION AND PARTS MANUAL — REV. #4 (06/03/10) — PAGE 45