DCA-15SPX4 — GAUGE READING/TERMINAL PANEL CONNECTIONS
UNV Terminal Output Voltages
240/120V output voltages can be obtained using the Output Terminal Lugs. Use the voltage regulator (VR) to either in- crease or decrease the selected voltage.
1Ø 120 Output Terminal Lug Voltages
1.Connect the load wires to the OutputTerminal Lugs as shown in (Figure 12)
Figure 12. Output Terminal Lugs
120 VAC Single Phase Connections
2.Turn the voltage regulator knob (Figure 13) clockwise to increase voltage output, turn counterclockwise to decrease voltage output.
Figure 13. Voltage Regulator Knob (139V/240V)
3.Observe that the output voltage either increases or decreases by monitoring the voltmeter (Figure 14) reading.
Figure 14. AC Voltmeter
Ammeter Gauge.
The ammeter gauge (Figure 15) on the generator control panel has been provided to help observe how much current (amps) is being supplied to the load from the output terminal lugs, GFCI receptacle or any auxulliary receptacles if installed.
Figure 15. AC Ammeter
The ammeter gauge will only
show a reading when the Output
NOTETerminal Lugs or auxillary receptacles are connected to a load.
1Ø 240 Output Terminal Lug Voltages
1.Connect the load wires to the OutputTerminal Lugs as shown in (Figure 16)
Figure 16. Output Terminal Lugs
240 VAC Single Phase Connections
2.Turn the voltage regulator knob (Figure 13) clockwise to increase voltage output, turn counterclockwise to decrease voltage output.
PAGE 26 —