NAMES AND FUNCTIONS
ENGLISH
NAMES AND FUNCTIONS
FRONT PANEL
q | w e r | t y u i o !0 |
BASIC CONNECTIONS BASIC
DISPLAY
TONE
OPERATE
SPEAKER
A
INPUT
SELECTOR
POWER ON/OFF
SPEAKER | PHONES |
B |
|
ATT.
PRE OUT
REC OUT
VOLUME
PHONO
MC
OPERATIONS ADVANCED
!4 | !3!2 | !1 |
q INPUT SELECTOR Knob | i ATT. Button | |
This knob is for selecting the input source to use in |
| This button attenuates the volume with one press of the |
playback and recording. The selected input source is |
| button. For instructions on How to Set the Attenuation |
displayed in the display !2. |
| Level, see page. 24. |
CONNECTIONS ADVANCED OPERATIONS TROUBLESHOOTING
OTHERS
wDISPLAY Button
This button turns the display and side illumination ON and OFF. For instructions on HOW TO OPERATE THE SIDE ILLUMINATION, see page. 24.
eTONE Button
This button turns the bass and treble tone control ON and OFF. For instructions on How to Trim Bass and Treble, see page. 23.
rSPEAKER A/B Buttons
These buttons turn the speaker output to the speakers connected to the SPEAKER SYSTEM A/B terminals on the rear panel ON and OFF. To listen with headphones, turn speaker output OFF.
tIllumination Lamp
The illumination lamp casts a blue light over the switches and buttons. It can be turned ON and OFF with the DISPLAY button. For instructions on HOW TO OPERATE THE SIDE ILLUMINATION, see page. 24.
yREC OUT Button
This button turns the signals output from the RECORDER 1 and 2 OUT jacks on the rear panel ON and OFF. When RECORDER 1 is selected as the input source, signals are not output to the RECORDER 1 OUT jack. The same goes for the RECORDER 2 OUT jack when RECORDER 2 is selected as the input source.
uPRE OUT Button
This button is for turning the output signal from the PRE OUT jacks on the rear panel ON and OFF.
oPHONO MC Button
This button switches the phono equalizer between MC and MM. When MC is set, the center of the button is lit a blue color. Set the phono equalizer amplifier according to the type of cartridge you use.
!0VOLUME Knob
This knob is for setting the volume. The volume level is displayed on the display !2. When turned slowly, the volume can be
!1Infrared Receptor Window
This receptor window receives control signals sent from the included remote controller.
!2Display
Indicate the selected input source, volume level, and setting status.
!3POWER ON/OFF Switch
This switch turns power to the unit ON and OFF. When pressed, power is activated and the blue indicator in the display !2lights up. Pressing the switch again turns the power OFF.
!4PHONES Jack
This jack is for connecting headphones with a standard stereo plug.
6