Marantz PM-11S2 manual ATT. Attenuation, HOW to Operate the Side Illumination, Illumination Lamp

NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATIONS ADVANCED CONNECTIONS ADVANCED OPERATIONS TROUBLESHOOTING

OTHERS

ENGLISH

ADVANCED OPERATIONS

ATT. (ATTENUATION)

	ATT. button
DISPLAY	ATT.
TONE	PRE OUT
SPEAKER	REC OUT
A
INPUT	VOLUME

SELECTOR

		POWER ON/OFF
SPEAKER	PHONES	PHONO
B		MC

ATT is a one-touch feature for reducing the volume level.When the ATT button on either the unit or remote controller is pressed, the volume level is attenuated.

1.When the ATT button on either the unit or the remote controller is pressed, “ATT” flashes on the display and the volume level is reduced.

When the ATT button is pressed again or the volume is increased/decreased using the controls, the mode is canceled and the original volume level is restored.

2.When the ATT button is pressed with the volume level at -∞(muted), the display will change as it is shown below appears for about 3 seconds, and attenuation is not applied.

7How to Set Attenuation Level

Attenuation level can only be set using the ATT button on the unit. The attenuation level can be set at –20dB, -40dB, or -∞. The factory default setting is -20dB.

1.Press and hold the ATT button on the unit for 2 seconds or longer. The attenuation level will appear on the display.

2.The attenuation level setting value changes with each press of the ATT button on the unit.

3.When the desired attenuation level setting appears on the display, leave it unchanged for 2 seconds or longer to enter the setting. Once entered, the display returns to the volume level indication.

HOW TO OPERATE THE SIDE

ILLUMINATION

DISPLAY button		Illumination Lamp
DISPLAY		ATT.
TONE		PRE OUT
SPEAKER		REC OUT
A
INPUT		VOLUME
SELECTOR
		POWER ON/OFF
SPEAKER	PHONES	PHONO
B		MC

The illumination lamp has an always-ON mode (factory setting) and an always-OFF mode.

In the always-ON mode, the illumination lamp turns ON/OFF in sync with the display.

1.With the illumination lamp lit, press and hold the DISPLAY button for 3 seconds or longer. The illumination lamp goes out, and the always-OFF mode is engaged.

2.To cancel the always-OFF mode and turn the illumination lamp ON, press and hold the DISPLAY button for 3 seconds or longer.

24