Land Pride AFM4214 manual Type B Clutch Clutch Run-In, Disassembly and Assembly

Land PrideTable of Contents

Section 5: Maintenance and Lubrication

Type B Clutch

Clutch Run-In

Refer to Figure 5-11:

1.Loosen counterclockwise all 8 hex head socket bolts uniformly 6 full turns.

2.Cycle clutch on and off 5 or 6 times (15 seconds on and 15 seconds off) with the engine operating at half throttle. Disengage driveline, shut off tractor and remove key. Wait for all components to stop before dismounting from tractor.

3.Tighten hex head socket bolts fully back. Clutch is ready for use

4.The clutch should be checked during the first hour of cutting and periodically each week.

Hex Head

Socket Bolts

(IMPORTANT NOTICE) Check position of lip on stop flange (UP or DOWN). Replace stop flange with lip in its original position.

21270

Type B Clutch Run-In

Figure 5-11

Disassembly and Assembly

Refer to Figure 5-12:

If the clutch run-in procedure indicated that one or more of the friction disks did not slip, then the clutch must be disassembled to separate the friction disks.

1. Rotate 8 hex head socket bolts (#2) all the way out to free stop flange (#3).

2. Rotate stop flange (#3) and remove from housing (#11)

3. Remove the following inner components:

a. Spring kit (#4)

b. Pressure flange (#5) c. 1st Friction Disc (#6)

d. Hub with flange and pull collar (#7 & #1) e. 2nd Friction disc (#6)

f. Intermediate flange (#8) g. 3rd Friction disc (#6) h. Hub disc (#9)

i. 4th Friction disc (#6) j. Bearing (#10)

4.	Inspect all components and replace to their original	22376
	position. Make certain stop flange (#3) is replaced	Type B Clutch Assembly
	with its flanges down as shown.
		Figure 5-12
5.	Fully tighten all 8 hex head socket bolts (#2).

11/14/08 AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M 29