Land Pride AFM4214 manual Table of Contents

Page 19

Land Pride

Table of Contents

 

Section 2:

Operating Instructions

 

 

 

 

 

 

 

 

 

 

Introduction

Hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance and storage of the Grooming Mower. Therefore, it is absolutely essential that no one operates the mower without first having read, fully understood and become totally familiar with the Operator’s Manual. Make sure the operator has paid particular attention to:

•Important Safety Information, pages 1 to 10

•Section 1: Assembly and Set-up,page 13

•Section 2: Operating Instructions, page 17

•Section 3: Adjustments, page 21

•Section 5: Maintenance and Lubrication, page 24

Hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance and storage of the mower.

IMPORTANT: Do not alter the Grooming Mower in a way which will adversely affect its performance or reliability or use the mower for a purpose for which it was not designed.

!DANGER

Before making adjustments or performing maintenance on your mower, disengage PTO, shut off tractor and wait for all moving parts to stop before dismounting tractor. Disconnect PTO driveline.

U-Joint Timing

Refer to Refer to Figure 2-1:

Transporting

!WARNING

Do not transport mower faster than 20 mph. When traveling on roadways, transport in such a manner that vehicles moving at a faster rate of speed may pass you safely.

!CAUTION

Care should be taken when encountering oncoming traffic and roadside obstructions if the mower is wider than your tractor.

!CAUTION

Always disengage tractor PTO before raising the Grooming Mower to transport position to avoid damaging the mower, injury from thrown objects or blade contact.

!CAUTION

When traveling on public roads, whether at night or during the day, use accessory lights and devices for adequate warning to operators of other vehicles. Comply with all federal, state, and local laws.

•Be sure to reduce tractor ground speed when turning; and, leave enough clearance so the mower does not contact obstacles such as buildings, trees or fences.

•Select a safe ground travel speed when transporting from one area to another. When traveling on roadways, transport in such a way that faster moving vehicles may pass you safely.

•When traveling over rough or hilly terrain, shift tractor to a lower gear.

Refer to Figure 2-2:

!CAUTION

On mowers equipped without slip clutches the deck drivelines (3 each) must be in time to avoid driveline damage when folding - unfolding

.

U-Joint Timing

Figure 2-1

1.Raise the 3 mower decks to the transport position by retracting all 3 cylinders completely.

2.As the mower decks are raising, the transport locks (3 each) will automatically lock in place when operating properly.

Spring Loaded

Transport Locks

13660

Pull Rope

Pull Ropes

Figure 2-2

11/14/08

AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M 17

Page 18 Page 20
Image 19
Page 18 Page 20
Contents All-Flex Grooming Mowers Table of Contents Safety at All Times Practice Safe Maintenance Use a Safety ChainTransport Machinery Safely Keep Riders Off Machinery Tire SafetyWear Protective Equipment Avoid High Pressure Fluids Hazard818-339C Safety Labels818-560C 818-019C 818-561C818-130C 818-351C 818-353C 818-337C818-555C 818-552C818-556C 818-045C818-513C 818-003C818-543C 818-230C 818-229C818-335C 818-552C 818-540C Introduction Using This ManualApplication Owner AssistanceLand Pride Service Department East North Street Hardware Torque Information Assembly and Set-upTractor Requirements Tractor Hook-up Check Constant Velocity Driveline Length Main Driveline InstallationAFM4216 Model Only Gauge Wheel AssemblyHydraulic Hook-up Pull Rope Hook-upBleeding The Fold Hydraulics Table of Contents Constant Velocity Shaft Constant Velocity Driveline AnglePre-Operation Instructions Operating Check ListAFM4214 & AFM4216 Models Operating InstructionsGeneral Operating Instructions Adjustments Deck Height AdjustmentsCutting Height Chart Excessive Belt Tension May Lead to Belt TensionNot Enough Belt Tension May lead to Cutting Blades Accessory Part NumbersAccessories Ball Swivel HitchBlade Inspection MaintenanceMaintenance and Lubrication Servicing Mower BladesLand PrideTable of Contents Blade Options Blade Sharpening Belt InstallationDriveline Protection Clutch Disassembly, Inspection & AssemblyType a Clutches Clutch Run-In Plate Assembly Step Plate Disassembly StepType B Clutch Clutch Run-In Disassembly and AssemblyTires With Air Pressure StorageLand Pride Aerosol Touch-up Paint Driveline Shafts Lubrication PointsHours Driveline Constant Velocity ShaftWheel Bushings Transport Hubs SeasonallyWheel Support Bushings Wheel Bushings Gauge WheelsMower Deck Gearbox RequiredBlade Spindle Bearings Way GearboxTransport Locks Tool Bar to Deck Pivot PinWing Deck Pivot Bushings Wing Flex Pivot Lugs Rear Deck Pivot Half ClampsSpecifications & Capacities Description Specification / CapacityAFM4214 Series 14044 AFM4216 Series 13665 Features Benefits Features & BenefitsAFM4214 & AFM4216 All-Flex Grooming Mower Troubleshooting Patches of uncut grass Problem Cause Solution Discharge openingsPlugged Belt slippingAdditional Torque Values Torque Values ChartTire Inflation Chart AppendixTable of Contents Overall Unit and Driveline One year Parts and Labor WarrantyCorporate Office P.O. Box Salina, Kansas 67402-5060 USA
Related manuals
Manual 88 pages 17.11 Kb
Top Page Image Contents