Important Safety Information
Installation must be carried out in accordance with these instructions, and must be conducted by designated, qualified and competent personnel.
Warning!
Follow all warnings, cautions and instructions contained in this guide, and on or inside the appliance.
1.Products manufactured by us are safe and
2.Isolate the electrical and water supplies before commencing installation. The electricity must be turned off at the mains and the appropriate circuit fuse removed, if applicable.
3.Mains connections are exposed when the cover is removed.
4.Refer to the wiring diagram before making any electrical connections (see internal wiring diagram at the back of the book).
5.Make sure that any pipework that could become frozen is properly insulated.
6.Having completed the installation, make sure that the user is familiar with the operation of the appliance.
7.Make sure that this guide is left with the user.
8.DO NOT commission this appliance if water leaks from the unit or the heater tank pressure relief valve.
9.DO NOT fit any form of outlet control (e.g. Trigger handset) as the outlet acts as a vent for the tank body. Only Mira recommended outlet fittings should be used.
10.Ensure all electrical connections are tight, to prevent overheating.
11.Warning! DO NOT operate this appliance if it is frozen. Allow the appliance to thaw before using. The shower unit must not be fitted where it may be exposed to freezing conditions.
12.This product is not suitable for areas with high humidity (i.e. steam rooms). Please consult your installer.
13.THIS APPLIANCE MUST BE EARTHED. ENSURE SUPPLEMENTARY BONDING COMPLIES WITH THE “REQUIREMENTS FOR ELECTRICAL INSTALLATIONS”.
In accordance with the current edition of “The Plugs and Sockets etc. (Safety) Regulations” in force at the time of installation, this Mira Escape is intended to be permanently connected to the fixed electrical wiring of the mains system.