2
Installation of Shower Fittings
Decide on a suitable position for the slide bar avoiding buried cables and pipes.
Drill the two 7.0 mm fixing holes for the slidebar at 600 mm centres and insert the wall plugs.
Assemble the clamp bracket components. Push the plastic slidebar ends into the slidebar.
Push the slidebar through the clamp bracket assembly, soapdish and hose retaining ring.
Fit the bottom end support loosely to the wall. This will make aligning the top support easier. Insert the fixing screw into the countersunk hole of the plastic slide bar end and through the slidebar support.
Place the screw through the top end support and fully tighten. Fully tighten the bottom end support.
Fit the end support caps over the slidebar end supports.
Screw the hose onto the handset and the outlet of the shower (Make sure the hose seals are fitted). Do not overtighten.
Place the handset into the slidebar clamp bracket.
Note! The clamp bracket is tapered. The handset will only fit properly from one direction. If necessary turn the end of the clamp bracket until the handset will fit.
If the clamp bracket pivots downwards under the weight of the handset the central securing screw in the bracket will require tightening to hold the handset in position.
15