Neckjet Operation (cont.)
To increase or decrease the neckjet flow volume, rotate the outer ring until the Flexjet flow mode is flashing, press ″OK″ and press either the up or down arrows on the keypad.
To activate or deactivate functions while the neckjets are operating, rotate the outer ring until the desired function is flashing and press ″OK.″ (Example: To turn the heater off, rotate the outer ring until the heater mode is flashing and press ″OK.″)
Press ″OK″ while the neckjet mode is active, to turn off the neckjets.
Press Power to turn off the whirlpool.
NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can restart the whirlpool, if you desire, by pressing Power.
Carefully exit the bath and open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to Troubleshooting in this manual.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
•Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use abrasive cleaners that may scratch or dull the surface.
•Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
•Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
•Do not allow cleaners to sit or soak on the surface.
•Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse and dry any overspray that lands on nearby surfaces.
•Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care & Cleaning information, call
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
•Turn the jet trim rings fully clockwise to remove air induction.
•Fill the whirlpool with warm water to a level at least 2″ (5.1 cm) above the highest jets, or leave water in the whirlpool after using.
•Add 2 tablespoons (30 ml) of a
•Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
•If desired, rinse the bath surfaces with water.
•Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
One-Year Limited Warranty
KOHLER plumbing products are warranted to be free of defects in material and workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co. inspection discloses any such defects occurring in normal usage within one (1) year after installation. Kohler Co. is not responsible for removal or installation costs. Use of
To obtain warranty service contact Kohler Co. either through your Dealer, Plumbing Contractor, Home Center or
| 6 | Kohler Co. |