TOWERS AND DOORS INSTALLATION
STEP 9 (2 WALL ONLY)
Place the side support rail into the slot on the water tower. Place the short wall rail into the slot on the other water tower. Rotate flat end of short wall rail flush to wall. With rails in position install hold down brackets, but do not tighten screws. Check water towers for level. Check side support rail for level and mark on the finished wall where to attach rail bracket. See DETAIL A. Drill 3/16" hole and secure bracket/short wall rail with screws and wall anchors provided. Slide cover cap over rail bracket. If a tower bolt was loosened, retighten while checking the plumb of the tower. Tighten screws on all hold down brackets.
STEP 9 (3 WALL ONLY)
Place the short wall rails into the slot on each water tower. Rotate flat end of short wall rails flush to wall. With rails in position install hold down brackets, but do not tighten screws. Check water towers and short wall rails for level. Drill 3/16" hole and secure short wall rails to wall with screws and wall anchors provided. If a tower bolt was loosened, retighten while checking the plumb of the tower. Tighten screws on all hold down brackets.
SIDE RAIL (2 WALL ONLY) | SIDE RAIL COVER BRACKET (2 WALL ONLY) |
RAIL BRACKET | ATTACH RAIL |
| |
| BRACKET TO WALL |
HOLD DOWN BRACKET |
|
COVER CAP | SECURE RAIL TO |
| BRACKET (TURN CW |
| TO TIGHTEN) |
CENTER SUPPORT RAIL |
|
SIDE RAIL |
|
WATER TOWER |
|
DOOR POST |
|
WATER TOWER JAMB |
|
| MOVE COVER CAP |
| OVER BRACKET |
| DETAIL A |
SHORT WALL RAIL (2 WALL AND 3 WALL)
FLAT END
FLUSH TO WALL
SHORT RAIL
(1 RAIL WITH 2 WALL) (2 RAILS WITH 3 WALL)
SHORT WALL RAIL MOUNTING
DRILL 3/16" HOLE
ATTACH RAIL
BRACKET TO WALL
11
Jacuzzi Whirlpool Bath© BZ00000 03/05