Honda Power Equipment HF2417HME, HF2417HTE, HF2620HME, HF2415SBE, HF2620HTE Troubleshooting

Page 61

EN 60

 

TROUBLESHOOTING

 

 

 

PROBLEM

LIKELY CAUSE

SOLUTION

6.Weak engine perfor- – forward speed too high in relation to

mance during cutting

cutting height (5.4.5)

reduce the forward speed and/or raise the cutting deck

7. Engine stops when

– you are not ready to engage the blades

blades are engaged

(5.2)

sit firmly on the seat (if problem contin- ues, check micro-switch)

check that the grass-catcher or stone- guard are correctly in position (if prob- lem continues, check micro-switch)

8. The battery warning

recharging of the battery insufficient

check connections

light does not turn off

 

 

 

 

after a few minutes’

 

 

 

 

work

 

 

 

 

 

 

 

 

9. The oil warning light

problems in lubricating the engine

Turn the key immediately to «STOP»:

comes on while work-

 

 

 

 

ing (

HF2220)

 

 

top up the oil level (5.3.3)

 

 

 

 

 

replace the filter (if the problem contin-

 

 

 

 

 

 

ues, contact your Dealer

 

 

 

 

 

 

 

10.The engine stops and an audible signal is heard

The protection of the electronic card has cut in due to:

battery contains electrolyte but is not charged

overvoltage caused by the charge reg- ulator

badly connected battery (poor contact)

engine badly earthed

Turn the key to «STOP» and look for the cause of the problem:

recharge battery (6.2.4)

contact your Dealer

check connections i (3.4)

check engine earth connection

11. The engine stops

battery disconnected

check connections (3.4)

with no audible warn-

no earth contact on engine

check the earth connection on the

ing

problems in the engine

 

engine

 

 

 

 

 

contact your Dealer

 

 

 

 

 

12. The blades warn-

the lever does not return to the disen-

free the joint of all the grass (accessed

ing light stays lit when

 

gaged position due to accumulated

 

from the inspection hatch)

the blades are disen-

 

grass cuttings at the end of its stroke

 

 

gaged

 

 

 

 

(

models with

 

 

 

 

lever operated

 

 

 

 

engagement)

 

 

 

 

 

 

 

 

 

 

 

13.The blades do not engage

(

 

models with

– cable lengthened or belt loosened

– turn the adjusting nut (6.3.3)

lever operated

 

 

engagement)

 

 

Image 61
Contents Tondeuse Autoportee LAWN-TRACTOR Rasentraktor Introduction AFTER-SALES ServiceTable of Contents HOW to Read the Manual Safety RegulationsOr others Death to oneself or othersRead carefully before using the machine Safety RegulationsMaintenance and Storage Regulations for Towing Safety DecalsIdentification of the Machine and Components HOW to Recognize Your MachineIdentification of the Machine Identification of Main Components Unpacking Unpacking and AssemblyFitting the Steering Wheel Connecting the Battery Front Bumper Assembly if fittedSame size to push the pin in the last part Fitting the SeatUting it evenly among the six elements Battery acid is corrosive and a pollutant. When handlingAssembling the Levers for Tipping the GRASS-CATCHER Wings 1a are turned inwardsGRASS-CATCHER Assembly HF2SBE HF2HME Controls and Instruments «SLOW» HF2SBE HF2HTE HF2620HME Stopped Pedal When the machine is in movement, keep your foot offIs engaged, the engine stops Safety Recommendations HOW to USEWHY the Safety Devices CUT 10 17%This may be avoided by keeping the push-button 4.7 pressed Preliminary Operations Before Starting Work Body, quickly remove perol traces On a flat surface and with the engine off, removeRefuelling should be car Protection devices must be fitted with Using the Machine Cutting deck put at its highest position position «7» Areas closed to trafficReleasing the drive pedal in forward or reverse Reverse must be engaged only when the machine is stoppedBlades Disengaged All four wheels, with the Engine OFFAt times the audible warning may be heard at the moment Unattended Netic clutch Next time the machine is used Right Using on Sloping GroundTransporting Advice on HOW to Obtain a Good CUT You will need to DirectionsEngine remove the grass-catcher and clean the channel Summary of the main situations where work may be required MaintenanceRoutine Maintenance Hours Periodic maintenanceLubrication Machine No device other than the battery charger is to be connected Removing the cutting deck Checks and AdjustmentsHaving checked that there is nothing HF24 HF26 Dismantling, sharpening and balancing blades For achieving good Put the height adjusting lever intoPut the machine onto a flat surface Check the tyre pressuresThree trace rods until the deck is resting on the blocks Spring length 2 is achieved measured Turn the adjusting nut 1 until the correctKeep the blade brake efficient Attempt Other Work on the Brake Than Described Here Dismantling and Replacement Wrench special tool Air cleaner element. a fire or explosion could resultNever run the engine without the air cleaner. Rapid engine BPR5ES NGK W16EPR-U Denso Air cleaner case when servicing the air cleanerWhen installing a new spark plug, tighten 1/2 turn after Carefully re-fit the snap ring 1 and washer Prevent an uneven cutType and rating, and never with one of another rating Wear! Always USE Genuine Replacement BeltsTroubleshooting Troubleshooting Models with STONE-GUARD KIT Accessories OptionalTowing Hitch Mulching PlugSpecifications Grass-catcher Alphabetical Index

HF2315SBE, HF2417HME, HF2315HME, HF2620HTE, HF2415SBE specifications

Honda Power Equipment has long been a trusted name in the outdoor power equipment industry, known for its innovative technology, reliability, and performance. Among its impressive lineup, the HF2417HTE, HF2620HME, HF2415SBE, HF2620HTE, and HF2315HME stand out as excellent options for both residential and commercial users, providing versatile and efficient solutions for landscaping and lawn care.

The HF2417HTE is tailored for those seeking high performance in a compact design. With a powerful 17 HP engine, it excels in heavy-duty applications while maintaining fuel efficiency. Its Hydrostatic Drive system guarantees smooth operation, allowing users to maneuver effortlessly across various terrains. The intuitive controls ensure ease of use, making it an ideal choice for both seasoned and novice operators.

Next up, the HF2620HME offers an even more robust solution. Boasting a 20 HP engine, this model is perfect for larger properties and commercial landscaping tasks. Its innovative features include a variable speed control that offers flexibility and precision, enabling operators to tackle different grass types and conditions seamlessly. The reinforced chassis enhances durability, ensuring a longer lifespan for the equipment while reducing maintenance needs.

The HF2415SBE is a lighter alternative, designed for smaller yards or gardens. Despite its smaller engine, it does not compromise on performance. This model features an easy-start mechanism and a user-friendly interface that simplifies operation. Additionally, its compact size allows for easy storage and maneuverability in tighter spaces, making it a great choice for home gardeners.

For those seeking advanced capabilities, the HF2620HTE is a standout. It includes Honda's advanced Auto Choke System, which eliminates the need for manual adjustment, leading to a more efficient start-up process, especially in varying weather conditions. This model also features enhanced noise reduction technology, making it quieter during operation, which is particularly beneficial for residential neighborhoods.

Lastly, the HF2315HME combines power with efficiency. Designed for those who require a robust yet manageable option, this model features a 15 HP engine, ideal for small to medium-sized properties. Its user-friendly design includes an ergonomic seat and controls, fostering comfort during longer work sessions.

Overall, Honda’s HF series offers a range of innovative features and robust designs catered to different landscaping needs, ensuring high performance, reliability, and user satisfaction in lawn care and maintenance.