GSI Outdoors PNEG-1597 manual 16 x 3-1/2 Hex head cap screws Flat washers

Page 15

3. Assembly

8.Bolt the shield bracket weldment to the front of the tractor frame using two (2) 3/8"-16 x 3-1/2" hex head cap screws, two (2) 3/8" flat washers (only on the bottom slot of the weldment) and

two (2) nuts.

3/8"-16 x 3-1/2"

Hex head cap screws

3/8" Flat washers

Figure 3D

PNEG-1597Sweep Tractor Assembly Instructions

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Sweep Tractor Assembly Instructions General Information Contents Free of Charge Safety Guidelines Follow Safety Instructions Safety InstructionsEye Protection Gloves Steel Toe Boots General Safety Guidelines Hazards Operator Qualifications Safety Decals Back Left Hand Sweep Tractor AssemblyBack Lug nuts 16 x 3-1/2 Hex head cap screws Flat washers 11 x 6 Threaded rods Assembly Gear motor assembly 11 x 6 Threaded rods Hex nuts X 1 Square key Tooth sprocket Roller chain Assembly 11 x 8-1/2 Threaded rod Flat washer End Wheel Assembly End Wheel AssemblyShield to Tractor Assembly Sweep Tractor to Shield AssemblySweep Tractor Parts Tractor Drive Parts List End Wheel Parts GSI Group Warranty
Top Page Image Contents