3. Assembly
End Wheel Assembly
NOTE: If installing sweep tractor to an existing sweep, the current end wheel components must be removed.
1.Connect stub into flighting using a 5/8" x 4" long hex head cap screw and 5/8" nylon lock nut.
2.Install bearing stand onto the stub shaft and bolt it to the sweep shield using a 3/8" x 3" hex head cap screw, a 3/8" x 3" long carriage bolt, flat washers, and nylon lock nuts.
3.Install the end wheel and collar onto the end of the stub shaft. Lock the collar in place with a 1/2" x
Sweep shield
Bearing stand weldment
Sweep flight
Stub shaft
End wheel 
Collar
Figure 3L End Wheel Assembly
22