GSI Outdoors PNEG-1597 manual Assembly

Page 17

3. Assembly

11.Mount the motor to the gear box plate using four (4) 3/8"-16 x 1" flanged bolts, then place over the threaded rods, resting on the hex nuts.

3/8"-16 x 1" Flanged bolts

Gear motor assembly

5/8"-11 x 6" Threaded rods

5/8"-11 Hex nuts

Figure 3G

PNEG-1597Sweep Tractor Assembly Instructions

17

Image 17
Contents Sweep Tractor Assembly Instructions General Information Contents Free of Charge Safety Guidelines Follow Safety Instructions Safety InstructionsEye Protection Gloves Steel Toe Boots General Safety Guidelines Hazards Operator Qualifications Safety Decals Back Left Hand Sweep Tractor AssemblyBack Lug nuts 16 x 3-1/2 Hex head cap screws Flat washers 11 x 6 Threaded rods Assembly Gear motor assembly 11 x 6 Threaded rods Hex nuts X 1 Square key Tooth sprocket Roller chain Assembly 11 x 8-1/2 Threaded rod Flat washer End Wheel Assembly End Wheel AssemblyShield to Tractor Assembly Sweep Tractor to Shield AssemblySweep Tractor Parts Tractor Drive Parts List End Wheel Parts GSI Group Warranty