3. Assembly
Sweep Tractor to Shield Assembly
1.Position sweep tractor against the sweep shield approximately 3' from the end wheel.
2.Use the bracket on the sweep tractor to mark the location where the holes need to be drilled into the sweep shield. You may need to adjust the bolts on the sweep tractor bracket to match the same height and angle on the sweep shield.
3.After marking the hole location, drill six (6) 7/16" holes and then attach the sweep tractor to shield using six (6) 3/8" x 1" hex head cap screws, six (6) flat washers, and six (6) 3/8" nylon lock nuts.
4.Install electric wiring for motor and controls.
All electrical wiring shall be installed by a qualified electrician and must meet the standards set by the National Electric Code and all local and state codes.
Adjustment bolts for adjusting the angle and height of the bracket (3/8" x 1" HHCS with flat washer’s nylon lock nut).
Sweep shield
Figure 3M Shield to Tractor Assembly
23 |