GSI Outdoors PNEG-1597 manual X 1 Square key Tooth sprocket Roller chain

Page 19

3. Assembly

13.Assemble the 13 tooth sprocket to the motor shaft using square key (1/4" x 1" long).

14.Install the roller chain around the sprockets. Adjust the position of the tractor axle (shaft) if necessary so as to align the chain correctly. Tighten the chain as required by adjusting the nuts on the 5/8"-11 x 6" threaded rod.

NOTE: Tighten bearing lock collar.

1/4" x 1" Square key

13 Tooth sprocket

Roller chain

Figure 3I

PNEG-1597Sweep Tractor Assembly Instructions

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Sweep Tractor Assembly Instructions General Information Contents Free of Charge Safety Guidelines Follow Safety Instructions Safety InstructionsEye Protection Gloves Steel Toe Boots General Safety Guidelines Hazards Operator Qualifications Safety Decals Back Left Hand Sweep Tractor AssemblyBack Lug nuts 16 x 3-1/2 Hex head cap screws Flat washers 11 x 6 Threaded rods Assembly Gear motor assembly 11 x 6 Threaded rods Hex nuts X 1 Square key Tooth sprocket Roller chain Assembly 11 x 8-1/2 Threaded rod Flat washer End Wheel Assembly End Wheel AssemblyShield to Tractor Assembly Sweep Tractor to Shield AssemblySweep Tractor Parts Tractor Drive Parts List End Wheel Parts GSI Group Warranty
Top Page Image Contents