Guardian Technologies 02010-2, 04164-3 owner manual Battery Installation, Optional Accessories

Page 36

Section 2 – Installation

Recreational Vehicle Generator

2.8BATTERY INSTALLATION

‹2.8.1 RECOMMENDED BATTERY

Install a battery that meets the following require- ments:

•The battery must be a 12-volt, automotive type storage battery.

•For prevailing ambient temperatures above 32° F (0° C), use a battery rated 70 amp-hours and capable of delivering 400 cold-cranking amperes.

•For prevailing ambient temperatures below 32° F (0° C), use a battery rated 95 amp-hours and capable of delivering 400 cold-cranking amperes.

NOTE:

If the battery is to be used to power other vehicle accessories, as well as start the generator, a bat- tery with a larger capacity may be needed.

‹2.8.2 BATTERY CABLES

Using battery cables that are too long or too small in diameter may cause a drop in voltage, which causes starting problems. For the best cold weather starting, the voltage drop between battery terminals and the generator connection point should not exceed 0.12 volts per 100 amperes of cranking current.

These generators are rated at about 100 DC amperes of cranking current.

Select battery cables based on (a) cable length and (b) prevailing ambient temperatures. Generally, the longer the cable and the colder the weather, the larger the cable size must be, as shown in the chart.

 

CABLE LENGTH

 

 

 

in Feet (meters)

CABLE SIZE

 

0 to 10 (0 to 3)

2*

 

 

11 to 15 (3.4 to 4.5)

0

 

 

16 to 20 (4.5 to 6)

000

 

 

 

 

 

*For warm weather, use No. 2 cable up to 20 feet.

‹2.8.3 BATTERY CABLE CONNECTIONS

1.Connect the battery cable from the battery post or terminal indicated by a POSITIVE, POS or (+) to the lug on the starter contactor (Figure 2.20).

NOTE:

Check to be sure the battery cable boot for the starter cable has been installed.

2.Connect the battery cable from the battery post indicated by a NEGATIVE, NEG or (-) to the frame ground connection (Figure 2.20).

3.Connect cables so the connectors are clean and tight.

Figure 2.20 – Connecting Battery Cables

‹2.8.4 BATTERY COMPARTMENT

Install the generator battery in its own, vented com- partment. Place the battery compartment away from any source of heat, sparks or flame.

Provide ventilation openings in the battery compart- ment. The minimum size of openings should be 2 square inches at the top of the compartment. Mount the battery on a strong, rigid supporting structure, where leaks and spills of battery fluid will not cause damage.

2.9OPTIONAL ACCESSORIES

A plug-in receptacle (Figure 2.21) is provided on the generator set, above the muffler enclosure. Use this receptacle to connect an optional remote-mounted start/stop panel to the generator. Installation of such a panel will permit starting and stoping the gen- erator engine from any convenient location inside the vehicle.

Figure 2.21 – Remote Panel Plug-in Receptacle

34

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Air-cooled Recreational Vehicle Generators Authorized Service Dealer Location IntroductionPart II Installation Instructions Inside Front Cover Warning   Electrical Hazards  Generator Identification ModelSafety SpecificationsGenerator Applicability Generator AC Connection System‹ 1.5.2 Optional Propane Fuel System ‹ 1.5.3 Fuel Consumption‹ 1.5.4 Engine OIL Requirements ‹ 1.5.6 GeneratorGenerator Control Panel Optional Remote START/STOP PanelAutomatic Choke Gasoline only Before Starting the Engine Starting the GeneratorSUMMER/WINTER Heat Riser System Stopping the Generator‹ 2.7.1 Letting the Engine Stabilize ‹ 2.9. LOW OIL Pressure Switch ‹ 2.9.2 High Temperature SwitchProtection Systems ‹ 2.8.1 do not Overload the GeneratorAdditional Information Checking the Engine OIL Level‹ 2.10.2 Operation in High Grass or Brush Maintaining the Engine AIR Cleaner ‹ 3.3.1 Cleaning the Foam PrecleanerChanging the Engine OIL AND/OR OIL Filter Clean AIR Intake Checking the Engine Spark PlugCleaning the Generator Battery MaintenanceFuel Filter Gasoline only Spark Arrestor MufflerOUT of Service Procedure ‹ 3.13.1 Removal from ServiceDrive Belt Exercising the Generator‹ 3.13.2 Return to Service Part  General Hazards   Fire Hazards  Purpose and Scope Manual Equipment DescriptionGenerator Engine Operating Speed Standards BookletsMajor Features and Dimensions Drawing 0F1127 Location and Support ‹ 2.1.1 Generator Location‹ 2.1.2 Generator Support Generator Compartments ‹ 2.1.4 Generator Restraint‹ 2.2.2 Compartment Construction ‹ 2.2.1 Compartment Size‹ 2.2.3 Sound Insulating Materials ‹ 2.2.4 Acoustics‹ 2.2.5 Compartment Floor Cutouts Typical Noise AbatementCooling and Ventilating AIR ‹ 2.3.1 Generator Airflow‹ 2.3.2 Cooling AIR Inlet Openings ‹ 2.3.4 Testing the Installation Gasoline Fuel System‹ 2.3.3 Compensating for Restrictions LP GAS Fuel System ‹ 2.4.2 Generator Fuel Supply Line‹ 2.5.1 Parts not Included in Fuel System ‹ 2.5.2 Some Important Considerations ‹ 2.5.3 Vapor Withdrawal‹ 2.5.5 Gaseous Carburetion Exhaust System ‹ 2.5.6 Fuel Supply Lines‹ 2.5.7 Excess Flow Valve ‹ 2.5.8 Leakage Tests‹ 2.6.3 Exhaust System Safety ‹ 2.6.1 Mufflers and Spark Arrestors‹ 2.6.2 Type of Exhaust System ‹ 2.7.1 Electrical Junction BOX‹ 2.7.2 Wiring ‹ 2.7.3 Generator AC Connections‹ 2.7.6 Power Supply Cord ‹ 2.7.7 Ground Fault Circuit InterruptersBattery Installation Optional AccessoriesPost Installation Tests Testing Under LoadBefore Initial START-UP Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionElectrical Data Electrical Data Exploded Views and Parts Lists Description Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists Description QTY 50 8 SCROLL, Flywheel Exploded Views and Parts Lists Piston Ring SET Exploded Views and Parts Lists MANIFOLD, Intake Your Warranty Rights and Obligations MANUFACTURER’S Emission Control System Warranty CoveragePURCHASER’S/OWNER’S Warranty Responsibilities Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule CONSUMER/PERSONAL Applications

04164-3, 02010-2 specifications

Guardian Technologies is proud to present the innovative 02010-2,04164-3 model, a standout product in its line of advanced air quality solutions specifically designed for modern homes. This cutting-edge air purifier is engineered to enhance indoor air quality, making it essential for those who prioritize a clean living environment.

One of the main features of the Guardian Technologies 02010-2,04164-3 is its powerful three-stage filtration system. This includes a pre-filter, a true HEPA filter, and an activated carbon filter, which work synergistically to capture a wide range of airborne pollutants. The pre-filter traps larger particles such as dust and pet hair, while the HEPA filter is capable of capturing 99.97% of allergens as small as 0.3 microns, including pollen, smoke, and mold spores. The activated carbon filter effectively reduces odors from pets, cooking, and smoke, providing a fresher living space.

In addition to its robust filtration capabilities, the 02010-2,04164-3 is equipped with Guardian Technologies' proprietary UVC light technology. This feature helps to further reduce airborne bacteria and viruses, giving users added peace of mind, especially in today’s health-conscious world. The UVC light works in conjunction with the filtration system to ensure a comprehensive level of air purification.

Another notable characteristic of this model is its compact and stylish design, making it suitable for any room in your home, whether it be the living room, bedroom, or office. Its lightweight construction allows for easy portability, letting users move it as needed for maximum efficiency.

The Guardian Technologies 02010-2,04164-3 also boasts user-friendly features, including a programmable timer and multiple fan speeds, allowing users to customize the airflow according to their preferences. Additionally, the quiet operation ensures that it does not disrupt daily activities or sleep, making it perfect for nighttime use.

In summary, the Guardian Technologies 02010-2,04164-3 air purifier combines advanced filtration technology, UVC light purification, and user-friendly features in a sleek design. It is an excellent choice for anyone looking to improve indoor air quality and create a healthier living environment.
Top Page Image Contents