Guardian Technologies 02010-2 ‹ 1.5.2 Optional Propane Fuel System, ‹ 1.5.3 Fuel Consumption

Page 8

Section 1 – General Information

Recreational Vehicle Generator

‹ 1.5.5 ENGINE

The manufacturer does not recommend using any gasoline containing alcohol (such as “gaso- hol”). If using any gasoline containing alcohol, it must not contain more than 10 percent ethanol, and it must be removed from the generator dur- ing storage. Do NOT use any gasoline containing methanol. If using gasoline with alcohol, inspect more frequently for fuel leaks and other abnor- malities.

‹1.5.2 OPTIONAL PROPANE FUEL SYSTEM

This generator is equipped with a liquid propane (LP) gas fuel system. LP gas is usually supplied as a liquid in pressure tanks.

The generator requires a vapor withdrawal type fuel system. This type of gaseous fuel system uses the vapors forming above the liquid fuel in the storage tank. Air temperature around the storage tank must be high enough to sustain adequate fuel vaporization. In colder climates, it may be necessary to use an inde- pendent heat source to be sure the fuel sufficiently vaporizes in the storage tank.

LP gas may consist of propane, butane or a mixture of the two gases. Propane vaporizes at temperatures as low as -20° F (-29° C), but butane returns to its liquid state when the temperature drops below about 32° F (0° C). For that reason, a higher ratio of propane is desired in the gas mixture when temperatures drop below freezing.

‹1.5.3 FUEL CONSUMPTION

 

Model

No Load

1/2 Load

Full Load

 

 

02010-2

0.32

0.46

0.76

 

04164-3

0.47/17.05

0.72/3.06

1.25/45.35

 

 

 

 

 

 

 

Gasoline is in gal/h.

LP is in gal/h and cf/h.

‹1.5.4 ENGINE OIL REQUIREMENTS

Use only high quality detergent oil rated with American Petroleum Institute (API) Service Classification SF, SG or SH. The recommended oil weights include the following:

•During summer months: SAE 30. An acceptable substitute is SAE 10W-30.

•During winter months: SAE 5W-30. DO NOT USE SAE 10-W40.

Crankcase and oil filter capacity is approximately 1,400 mL or 1.5 U.S. quarts. Do NOT use special additives. See "Checking the Engine Oil Level" and "Changing the Engine Oil and/or Oil Filter" sections for oil level check and fill procedures.

Type of Engine

GN-410, Single-cylinder

Cooling Method

Air-cooled

Rated Horsepower

15 @ 4,200 rpm

Displacement

407cc

Cylinder Block

Aluminum w/Cast Iron Sleeve

Type of Governor

Mechanical, Fixed Speed

Air Cleaner

Paper Element w/Foam Precleaner

Starter

12-volt DC Electric

Ignition System

Solid-state w/Flywheel Magneto

Recommended Spark Plug

 

Champion

RC14YC

AC

R45S

Fram Autolite

65

Spark Plug Gap

0.030 inch (76 mm)

Recommended Minimum Battery

400 Cold-cranking

 

 

Amperes

‹1.5.6 GENERATOR

Rated Maximum Continuous

 

AC Output (Gasoline)

4,800 Watts (4.8 kW)

AC Output (LP Fuel)

4,500 Watts (4.5 kW)

Rated Voltage

120 Volts AC*

Rated Maximum Continuous

 

AC Current (Gasoline)

40 Amperes**

AC Current (LP Fuel)

37.5 Amperes**

Phase

Single

Rotor RPM

3,600

Number of Rotor Poles

2

Engine RPM

2,571

Rated AC Frequency

60 Hz

Battery Charge Voltage

14 Volts DC

Battery Charge Current

2 Amperes (max)

Weight

 

Gasoline

198 Pounds

LP Fuel

200 Pounds

Length

25.5 inches (648 mm)

Width

18.88 inches (479 mm)

Height

16.75 inches (425 mm)

*All units are reconnectable to 120- and/or 240-volt, dual voltage output. Units are no longer listed per RVIA/ANSI when recon- nected for dual voltage output.

**If reconnected for dual voltage, the ampere rating for 240 volts is 20 AC amperes for model 02010-2, and 18.8 AC amperes for model 04164-3.

‹1.5.7 EMISSIONS COMPLIANCE PERIOD

For non-handheld engines the Emissions Compliance Period referred to on the Emissions Compliance Label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements.

•For engines less than 225 cc displacement, Category C=125 hours, B=250 hours, and A=500 hours.

•For engines of 225 cc or more, Category C=250 hours, B=500 hours, and A=1000 hours.

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Air-cooled Recreational Vehicle Generators Authorized Service Dealer Location IntroductionPart II Installation Instructions Inside Front Cover Warning   Electrical Hazards  Generator Identification ModelSafety SpecificationsGenerator Applicability Generator AC Connection System‹ 1.5.2 Optional Propane Fuel System ‹ 1.5.3 Fuel Consumption‹ 1.5.4 Engine OIL Requirements ‹ 1.5.6 GeneratorAutomatic Choke Gasoline only Generator Control PanelOptional Remote START/STOP Panel Before Starting the Engine Starting the Generator‹ 2.7.1 Letting the Engine Stabilize SUMMER/WINTER Heat Riser SystemStopping the Generator ‹ 2.9. LOW OIL Pressure Switch ‹ 2.9.2 High Temperature SwitchProtection Systems ‹ 2.8.1 do not Overload the Generator‹ 2.10.2 Operation in High Grass or Brush Additional InformationChecking the Engine OIL Level Changing the Engine OIL AND/OR OIL Filter Maintaining the Engine AIR Cleaner‹ 3.3.1 Cleaning the Foam Precleaner Clean AIR Intake Checking the Engine Spark PlugCleaning the Generator Battery MaintenanceFuel Filter Gasoline only Spark Arrestor MufflerOUT of Service Procedure ‹ 3.13.1 Removal from ServiceDrive Belt Exercising the Generator‹ 3.13.2 Return to Service Part  General Hazards   Fire Hazards  Purpose and Scope Manual Equipment DescriptionGenerator Engine Operating Speed Standards BookletsMajor Features and Dimensions Drawing 0F1127 ‹ 2.1.2 Generator Support Location and Support‹ 2.1.1 Generator Location Generator Compartments ‹ 2.1.4 Generator Restraint‹ 2.2.2 Compartment Construction ‹ 2.2.1 Compartment Size‹ 2.2.3 Sound Insulating Materials ‹ 2.2.4 Acoustics‹ 2.2.5 Compartment Floor Cutouts Typical Noise Abatement‹ 2.3.2 Cooling AIR Inlet Openings Cooling and Ventilating AIR‹ 2.3.1 Generator Airflow ‹ 2.3.3 Compensating for Restrictions ‹ 2.3.4 Testing the InstallationGasoline Fuel System ‹ 2.5.1 Parts not Included in Fuel System LP GAS Fuel System‹ 2.4.2 Generator Fuel Supply Line ‹ 2.5.5 Gaseous Carburetion ‹ 2.5.2 Some Important Considerations‹ 2.5.3 Vapor Withdrawal Exhaust System ‹ 2.5.6 Fuel Supply Lines‹ 2.5.7 Excess Flow Valve ‹ 2.5.8 Leakage Tests‹ 2.6.3 Exhaust System Safety ‹ 2.6.1 Mufflers and Spark Arrestors‹ 2.6.2 Type of Exhaust System ‹ 2.7.1 Electrical Junction BOX‹ 2.7.2 Wiring ‹ 2.7.3 Generator AC Connections‹ 2.7.6 Power Supply Cord ‹ 2.7.7 Ground Fault Circuit InterruptersBattery Installation Optional AccessoriesPost Installation Tests Testing Under LoadBefore Initial START-UP Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionElectrical Data Electrical Data Exploded Views and Parts Lists Description Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists Description QTY 50 8 SCROLL, Flywheel Exploded Views and Parts Lists Piston Ring SET Exploded Views and Parts Lists MANIFOLD, Intake PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule CONSUMER/PERSONAL Applications

04164-3, 02010-2 specifications

Guardian Technologies is proud to present the innovative 02010-2,04164-3 model, a standout product in its line of advanced air quality solutions specifically designed for modern homes. This cutting-edge air purifier is engineered to enhance indoor air quality, making it essential for those who prioritize a clean living environment.

One of the main features of the Guardian Technologies 02010-2,04164-3 is its powerful three-stage filtration system. This includes a pre-filter, a true HEPA filter, and an activated carbon filter, which work synergistically to capture a wide range of airborne pollutants. The pre-filter traps larger particles such as dust and pet hair, while the HEPA filter is capable of capturing 99.97% of allergens as small as 0.3 microns, including pollen, smoke, and mold spores. The activated carbon filter effectively reduces odors from pets, cooking, and smoke, providing a fresher living space.

In addition to its robust filtration capabilities, the 02010-2,04164-3 is equipped with Guardian Technologies' proprietary UVC light technology. This feature helps to further reduce airborne bacteria and viruses, giving users added peace of mind, especially in today’s health-conscious world. The UVC light works in conjunction with the filtration system to ensure a comprehensive level of air purification.

Another notable characteristic of this model is its compact and stylish design, making it suitable for any room in your home, whether it be the living room, bedroom, or office. Its lightweight construction allows for easy portability, letting users move it as needed for maximum efficiency.

The Guardian Technologies 02010-2,04164-3 also boasts user-friendly features, including a programmable timer and multiple fan speeds, allowing users to customize the airflow according to their preferences. Additionally, the quiet operation ensures that it does not disrupt daily activities or sleep, making it perfect for nighttime use.

In summary, the Guardian Technologies 02010-2,04164-3 air purifier combines advanced filtration technology, UVC light purification, and user-friendly features in a sleek design. It is an excellent choice for anyone looking to improve indoor air quality and create a healthier living environment.
Top Page Image Contents