Great Dane GDRZ25KHE, GDRZ26KHE, GDRZ25KAE manual G, unless the bearings need to be replaced

Page 30

SERVICE MISCELLANEOUS

B

A

C

J

F

L

G

I

H

E

D

MX9224

3.Remove cap (A), cotter pin (B), castle nut (C), caster yoke and wheel assembly (D) and caster bushing (E).

NOTE: It is not necessary to remove the bearing races

(F) and (G), unless the bearings need to be replaced.

4.Remove seal (H) and lower bearing (I).

5.Remove upper bearing (J).

6.Clean and inspect bearings (I) and (J); pack with clean grease. Replace bearings if needed.

7.Install lower bearing (I) and a new seal (H).

8.Install upper bearing (J).

NOTE: Do not overtighten castle nut (C). Tighten castle nut only enough to remove excess play from bearings. Align crossdrill and nut to allow installation of the cotter pin (B). The caster wheel yoke assembly must be free to rotate.

9.Install caster bushing (E) on yoke shaft, and install caster yoke and wheel assembly (D), castle nut (C), and cotter pin (B).

10.Apply grease to lubrication fitting (L) until you can see grease at the top bearing (J). Install grease cap (A).

Service Miscellaneous - 27

Image 30

Contents OPERATOR’S Manual Special Messages Using Your Operator’s ManualIntroduction Record Identification NumbersTable of Contents Safety Understanding The Machine Safety LabelsEmission Compliance Period Small Off-Road Gas Engines Operating SafelyAgency Category Hours Rotating Blades are Dangerous Checking Mowing AreaParking Safely Avoid TippingChecking Wheel Bolts Practice Safe MaintenanceKeep Riders Off Driving Safely on Public RoadsHandling Fuel Safely Tire SafetyPrevent Fires Fuel and fuel vapors are highly flammable and explosiveOperating Daily Operating ChecklistTesting Safety Systems Console Controls Operating ControlsTesting Neutral Start Safety Switch Testing Park Brake Safety SwitchTesting Park Brake Testing Seat Safety SwitchStopping the Machine Adjusting Cutting HeightOperating the Machine To drive the machine forward Push both control leversUsing the Fuel Shutoff Valve Moving the Machine ManuallyPicture Note Left pump shown Replacement Parts PartsPart Numbers Service Intervals Spray Lubricant Service LubricationGrease Lubrication PointsService Engine Adjusting Carburetor Checking Spark PlugReplacing Fuel Filter Transmission Oil Service TransmissionAdjusting Transmission Neutral Position Checking Transmission Oil LevelRemoving and Installing Traction Drive Belt Bleeding Hydraulic SystemRaise drive wheels off the ground and block caster wheels Service Mower Adjusting Mower LevelAdjust Cutting Height Checking and Adjusting Mower Deck Drive Belt Tension Removing and Installing Mower Deck Drive BeltsChecking for Bent Mower Blades Servicing Mower BladesBalancing Mower Blades Replacing Mower Spindle Bearings Replacing Mower Deck Idler Pulleys Service Electrical Removing and Installing the BatteryChecking Battery Electrolyte Level Cleaning Battery and Terminals Check and Adjust PTO Clutch Air GapReplacing Fuses Kohler Wiring Schematic Checking Wheel Nuts Service MiscellaneousFilling Fuel Tank Servicing Caster Wheel Roller BearingsG, unless the bearings need to be replaced Engine TroubleshootingUsing Troubleshooting Chart CheckElectrical Machine OperationMower Troubleshooting Preparing Machine for Storage Storing SafetyStorage Preparing Fuel and Engine for StorageAssembly Check Tire Pressure Initial AdjustmentsPTO Clutch Run-in Procedure Level Mower DeckSpecifications Index Belt, Replacing Mower Drive PrimaryPage Service Record GD Record Service Dates