Generac Power Systems 004916-0 Unpacking/Inspection, Protection Systems, System SET LED

Page 6

Section 1 — General Information

Air-cooled 11 kW Generators

DANGER

Only qualified electricians or contractors should attempt such installations, which must comply strictly with applicable codes, standards and regulations.

1.1UNPACKING/INSPECTION

After unpacking, carefully inspect the contents for damage.

•This standby generator set has been factory sup- plied with a weather protective enclosure that is intended for outdoor installation only.

If this generator is used to power electrical load circuits normally powered by a utility power source, it is required by code to install a transfer switch. The transfer switch must effectively iso- late the electrical system from the utility distri- bution system when the generator is operating (NEC 700, 701 & 702). Failure to isolate an electri- cal system by such means will result in damage to the generator and also may result in injury or death to utility power workers due to backfeed of electrical energy.

If any loss or damage is noted at time of delivery, have the person(s) making the delivery note all damage on the freight bill or affix their signature under the consignor's memo of loss or damage.

If a loss or damage is noted after delivery, separate the damaged materials and contact the carrier for claim procedures.

“Concealed damage” is understood to mean damage to the contents of a package that is not in evidence at the time of delivery, but is discovered later.

1.2PROTECTION SYSTEMS

Unlike an automobile engine, the generator may have to run for long periods of time with no operator pres- ent to monitor engine conditions. For that reason, the engine is equipped with the following systems that protect it against potentially damaging conditions:

1.

Low Oil Pressure Sensor

4.

Overspeed

2.

High Temperature Sensor

5.

Low Battery

3.

Overcrank

 

 

1.3SYSTEM SET LED

The “System Set” LED is lit when all of the following conditions are true:

1.The AUTO/OFF/MANUAL switch is set to the AUTO position.

2.The utility voltage being supplied to the unit is being sensed by the PCB. If the utility sense volt- age is not connected to the unit or if it is below 168 volts AC, then the system set light will flash rapidly. This indicates that if the AUTO/OFF/ MANUAL switch is placed in the Auto position , the generator will start.

3.The “Not In Auto” dip switch is set to the OFF position on the control board.

4.No alarms are present, for example, low oil pres- sure, high temperature, etc.

1.4ACCESSORY FEATURES

‹1.4.1 12 VOLT DC OUTLET

The generator is equipped with a 12 volt DC accesso- ry outlet located in the system control panel (Figure 1.1). With the generator running or in standby mode, this outlet may be used to temporarily power low power accessories such as an inspection light, cell phone, radio or other automotive style accessory with a 7.5 amp maximum current draw.

Figure 1.1 — 12 Volt DC Outlet

AUTO

SET

EXERCISE

TIME

OFF

SYSTEM

FUSE

15A

MANUAL

 

EXTERNAL

 

GFCI

ACCESSORY

CIRCUIT

OUTLET

BREAKER

 

OUTLET

 

FUSE

 

7.5A

12VDC

 

7.5A MAX.

There are LED readouts on the control panel to notify the user that one of these faults has occurred. There is also a “System Set” LED that is lit when all of the conditions describe in Section 1.3 are true.

The 12 volt DC accessory socket is not intended for continuous use. Power for this socket is drawn from the engine battery. Extended use will drain the battery and the engine may not start. Power available at this socket is limited to 7.5 amps maximum.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Installation Introduction Authorized Dealer LocationTroubleshooting  Warning   Electrical Hazards  ‹ Standards IndexProtection Systems Accessory FeaturesUNPACKING/INSPECTION System SET LEDGenerator ‹ 1.4.2 120 Volt AC OutletSpecifications ‹ 1.6.1 Generator‹ 1.6.2 Engine Fuel Consumption Reconfiguring Fuel SystemFuel Requirements Recommendations LocationBattery Installation Battery‹ 1.10.2 Transfer Switch Check Transfer Switch Operation Electrical ChecksBefore Initial START-UP Generator Tests Under Load Checking Automatic OperationVoltage Regulator Adjustment BREAK-IN Procedure‹ 3.2.1 Auto Position ‹ 3.2.2 OFF Position Automatic Transfer OperationSequence of Automatic Operation ‹ 3.2.3 Manual Position‹ 3.6.2 High Temperature Switch Setting the Exercise Timer‹ 3.6.1 LOW OIL Pressure Switch ‹ 3.6.3 OvercrankChecking the Engine OIL Level ‹ 3.6.5 LOW BatterySystem Fuse Changing the Engine OILChanging the OIL Filter Changing the Engine AIR Cleaner‹ 4.3.2 OIL Change Procedure Spark PlugsBattery Maintenance Adjusting GT-990 Valve ClearanceCorrosion Protection OUT of Service Procedure‹ 4.12.1 Removal from Service Cooling System‹ 4.12.2 Return to Service Service Schedule Be performed by the nearest Authorized DealerTroubleshooting Guide Problem Cause CorrectionInstallation Diagram Control Panel BOX Customer Connection Charger Engine Alternator Exploded Views and Parts Lists Part NO. QTY Description Air-cooled 11 kW Generators Control Panel Drawing No E4879-D ASSEMBLY, Home Standby Exploded Views and Parts Lists QTY Description 102 Screw Hhtt M6-1.0 X 10 YC Alternator Air-cooled Pulleys Drawing KW Generators No E4880 FRAME, Mounting SS HSB Air-cooled 11 kW Generators Regulator Drawing No E4881-C CASTING, Twin Regulator Housing Air-cooled 11 kW Generators Air-cooled 11 kW Generators Your Warranty Rights and Obligations MANUFACTURER’S Emission Control System Warranty CoveragePURCHASER’S/OWNER’S Warranty Responsibilities Emission Control System Warranty Emission Related Parts Include the FollowingGenerac Power SYSTEMS, INC

004916-0 specifications

Generac Power Systems 004916-0 is a robust and efficient solution for home and commercial power needs, designed to provide reliable electricity during outages and emergencies. This model is a standout generator, well-regarded for its technology and features that cater to users looking for both performance and dependability.

One of the main features of the 004916-0 is its powerful engine. It is equipped with a Generac G-Force engine, which is engineered for durability and high performance. This engine provides a reliable source of power, ensuring that homes and businesses can maintain essential functions during power interruptions. Its impressive starting capability and consistent performance make it a trusted choice for many users.

The generator also boasts an automatic transfer switch, which facilitates a smooth transition to generator power when the grid goes down. This feature minimizes disruption, as it ensures that critical systems like refrigeration, heating, and medical equipment remain operational without manual intervention. The transfer switch allows the generator to kick in within seconds of detecting a power loss, providing peace of mind for users.

In terms of technology, the 004916-0 incorporates advanced features such as Mobile Link™ remote monitoring. This innovative technology allows users to monitor the status of their generator from anywhere via a smartphone or tablet. Users can easily check power levels, receive maintenance alerts, and ensure that their system is running efficiently, providing enhanced control and convenience.

Another notable characteristic is its innovative enclosure design, which minimizes noise during operation. This makes the 004916-0 suitable for residential areas where noise pollution can be a concern. The generator's sound-dampening technology ensures that it operates quietly, providing a more pleasant environment for users and neighbors alike.

Additionally, the generator is built with user-friendly controls, allowing for easy start-up and operations. The intuitive interface simplifies monitoring and adjustments, making it accessible even for those who may not be technically inclined.

Generac Power Systems 004916-0 represents a blend of power, reliability, and advanced technology, making it a top choice for anyone seeking a dependable backup power solution. Its features are designed to meet the challenges of modern power outages, offering users the comfort and security they need in times of uncertainty. Whether for home or business use, the 004916-0 stands out as a reliable partner in power management.
Top Page Image Contents