Generac Power Systems 05176-0 owner manual ‹ 5.12.2 Return to Service

Page 24

Section 5 — Maintenance

Air-cooled 15 kW Generators

‹5.12.2 RETURN TO SERVICE

To return the unit to service after storage, proceed as follows:

1.Set the generator’s main circuit breaker to its OFF (or OPEN) position.

2.Verify that utility power is turned off and that the AUTO/OFF/MANUAL switch is set to OFF.

3.Check the tag on the engine for oil viscosity and classification. Verify that the correct recom- mended oil is used in the engine (see "Enging Oil Requirements"). If necessary, drain and refill with the proper oil.

4.Check the state of the battery. Fill all cells of unsealed batteries to the proper level with dis- tilled water. DO NOT USE TAP WATER IN THE BATTERY. Recharge the battery to 100 percent state of charge, or, if defective, replace the bat- tery. See the “Specifications” section for type and size.

5.Clean and wipe the entire generator.

6.Remove the 5A fuse from the generator control panel.

7.Reconnect the battery. Observe battery polarity. Damage may occur if the battery is connected incorrectly. Replace the 5A fuse in the generator control panel.

8.Open the fuel shutoff valve.

9.Start the unit by moving the AUTO/OFF/MANUAL switch to MANUAL. Allow the unit to warm up thoroughly.

10.Stop the unit and set the AUTO/OFF/MANUAL switch to AUTO. Set the generator’s main circuit breaker to its ON (or CLOSED) position.

11.Turn on the utility power to the transfer switch.

12.The generator is now ready for service.

NOTE:

If the battery was dead or disconnected, the exer- cise timer must be reset.

22

Image 24
Contents Installation Introduction Authorized Dealer LocationSection Troubleshooting  Warning   Electrical Hazards  ‹ Standards IndexUNPACKING/INSPECTION Protection SystemsSystem SET LED Automatic Transfer Switch GeneratorSpecifications Reconfiguring Fuel SystemFuel Requirements Recommendations Fuel ConsumptionInstallation ‹ 2.1.1 Remote Monitoring Connections‹ 2.1.3 Transfer Switch Connection ‹ 2.1.2 Roof Open AlarmBattery Installation Check Transfer Switch Operation Battery Before Initial START-UPElectrical Checks Generator Tests Under Load Adjusting the Regulator Natural GAS only Checking Automatic OperationVoltage Regulator Adjustment Engine Governor AdjustmentSequence of Automatic Operation Automatic Transfer Operation‹ 4.1.1 Auto Position ‹ 4.1.3 Manual PositionManual Operation ‹ 4.4.1 Close to Normal Source SideVoltage Checks ‹ 4.4.2 Close to Emergency Source Side‹ 4.4.3 Return to Normal Source Side Setting the Exercise Timer ‹ 4.8.1 LOW OIL Pressure Switch‹ 4.8.2 High Temperature Switch ‹ 4.8.3 OvercrankChanging the Engine OIL Checking the Engine OIL Level‹ 4.8.4 Overspeed ‹ 5.3.1 Engine OIL RecommendationsChanging the Engine AIR Cleaner Changing the OIL FilterSpark Plugs Battery Maintenance Adjusting Valve ClearanceOUT of Service Procedure ‹ 5.12.1 Removal from ServiceCooling System Corrosion Protection‹ 5.12.2 Return to Service Service Maintenance Interval Information ‹ 7 KW 40 KW Small Standby Generator SetsMaintenance Level Level5 Tasks Maintenance Level Troubleshooting Guide Problem Cause CorrectionMounting Dimensions Electrical Data Control Panel BOX Transfer Switch 1VA GTS Exploded Views and Parts Lists Part NO. QTY. Description Air-cooled 15 kW Generators Control Panel Drawing No F5846 Description Exploded Views and Parts Lists Item Part NO. QTY. Description Exploded Views and Parts Lists Part NO. QTY Description Exploded QTY Description 7KW CASTING, Twin Regulator Housing Exploded Views and Parts Lists LUG Sldlss 250-#6 AL/CU Your Warranty Rights and Obligations MANUFACTURER’S Emission Control System Warranty CoveragePURCHASER’S/OWNER’S Warranty Responsibilities Emission Control System Warranty Emission Related Parts Include the FollowingGenerac Power Systems Standard Limited Warranty for

05176-0 specifications

Generac Power Systems 05176-0 is a powerful home standby generator designed to provide reliable backup power during outages. Known for its innovative technology and robust features, the 05176-0 model is part of Generac's Guardian Series, which is renowned for its reliability and ease of use.

One of the standout features of the Generac 05176-0 is its Generac G-Force engine, which is designed specifically for generator use. This automotive-grade engine is built to handle the rigors of prolonged operation, ensuring that homeowners have a dependable source of power. With a power output of 22 kW, it can handle the essential electrical loads of many homes, allowing users to power their lights, appliances, HVAC systems, and other necessary devices without interruption.

The 05176-0 comes equipped with a state-of-the-art transfer switch that automatically detects outages and begins the power restoration process within seconds. This automatic transfer switch eliminates the need for manual intervention, giving homeowners peace of mind that their power supply will seamlessly transition during a grid failure.

In terms of fuel efficiency, the Generac 05176-0 operates on either natural gas or liquid propane, providing flexibility for installation and operation. Its dual-fuel capability allows users to choose the fuel source that is most convenient and cost-effective for them.

Another notable feature is the generator’s Quiet-Test technology, which runs the generator at reduced RPMs for a self-test every week. This helps to ensure that the generator is operational and ready when needed while minimizing noise pollution in residential areas.

The model also boasts an intuitive LCD display that provides real-time information on the generator's status, including maintenance intervals and diagnostic information. This user-friendly interface simplifies monitoring and helps ensure that users can maintain optimal performance.

Moreover, the construction and design of the 05176-0 are intended for durability and weather resistance. With a robust enclosure made from high-quality materials, it is built to withstand harsh weather conditions, allowing homeowners to trust that their generator will perform reliably in any situation.

Overall, the Generac Power Systems 05176-0 stands out as a premium choice for homeowners seeking a reliable, efficient, and easy-to-use standby generator. Its combination of power output, advanced technology, and user-friendly features makes it an essential investment for anyone looking to ensure that they remain powered during outages.