Dixon ZTR 5022 Care And Maintenance, Changing The Engine Oil, Protect Your Investment, Oil Fill

CARE AND MAINTENANCE

CAUTION	HOT oil may cause burns.
	Allowenginetocoolbeforedrainingoil.

CHANGING THE ENGINE OIL:

1.The "snap lock" oil drain valve is located on the left side of the engine crankcase.

2.Place a suitable container under the drain valve. The short piece of hose will help direct the oil.

3.Push the valve body in and twist to clear the detent notch.

4.Pulling the valve body outward will start the flow of oil.

NOTE: Refer to engine manufacturers recommendations for frequency of oil changes.

TOENGINE	CLOSED	OPEN
8429

OIL FILL:	Push the valve body in and twist into the detent notch.
1.
2.	Clean any spilled oil from engine and chassis.
3.	Refill engine with type, and quantity of oil recommended by the engine
	manufacturer in engine literature.

NOTE: Engine oil changes on the 5000 Series Models will require replacement of the oil filter. These filters can be obtained from any authorized Kohler engine dealer.

PROTECT YOUR INVESTMENT:

The use of non-original oil or air filters may result in damage to the engine and a loss of warranty. Listed on Page 41 are the correct part numbers for each engine in the 5000 Commercial Series.

PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS

PROTECT YOUR ENVIRONMENT

Page 32