| SPECIFICATIONS | |
|
| Model ZTR 5017 |
CHASSIS: | 11 GA - rectangular tube | |
BODY: | Two piece - made of rotational molded polyethylene. Front body contains | |
| access panels for battery service and engine to mower deck belt removal. Rear | |
| body tilts up to allow service on the entire drive system. | |
SEAT: | Designed for operator comfort by use of high density closed cell foam padded | |
| back and arm rests, upholstered with CorduraTM | |
| adjustable fore and aft. | |
MOWER DECK: | 13 GA stamped steel construction | |
| 3 blades combine for a 42" cut width | |
| Cut height approximately 1.5" to 4.5" via 7 position lift handle | |
BLADE DRIVE: | Electric clutch | |
DRIVE SYSTEM: | Each rear wheel is independently driven by a HydroGear | |
| hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully | |
| enclosed HydroGear gearbox. | |
ENGINE: | 17HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full | |
| pressure lube system, dual element air cleaner, impulse fuel pump | |
STARTING SYSTEM: | Electric by key switch operation with safety interlocks on parking brake and | |
| blade drive clutch. | |
TIRES: | Front | 11 X 4 X 5 smooth profile |
| Rear | 20 X 10.5 X 8 Multi Trac |
RECOMMENDED | Front | 16 - 21 lbs. |
TIRE PRESSURE: | Rear | 8 - 14 lbs. |
CAPACITIES: | Fuel - 4.8 gallons total (dual tanks) | |
| Hydrostat oil tank - 3 quart with | |
| Hydrostat oil recommendation, refer to page 37 | |
| Engine - 2 qts. SAE 30 (with filter) | |
DIMENSIONS: | Width | 54" |
| Height | 45" |
| Length | 72" |
| Weight | 615 lbs. |
NOTE: | Additional information provided in service instructions under the individual component. | |
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 12