Dixon ZTR 5004, ZTR 5005 manual Specifications

Page 13

 

SPECIFICATIONS

 

Model ZTR 5004/5005

CHASSIS:

11 GA - rectangular tube

BODY:

Two piece-made of rotational molded polyethylene. Front

 

body contains access panels for battery service & engine

 

to mower deck belt removal. Rear body tilts up to allow

 

service on the entire drive system.

SEAT:

Designed for operator comfort by use of high-density

 

closed cell foam padded back rest and arm rests,

 

upholstered with CorduraTM water-repellent fabric. Seat

 

is adjustable fore and aft.

MOWER DECK:

Two decks are available. The 42” is made of stamped

 

steel. The 50” is made of 11 GA fabricated welded

 

construction with external reinforcement ribs. Three

 

blades combine for either a 42” or 50” cut width. Cut

 

height approximately 1.5” to 4.5” via 7 position lift handle.

BLADE DRIVE:

Electric clutch

DRIVE SYSTEM:

Each rear wheel is independently driven by a HydroGear

 

BDU-10L Series 70 hydrostatic transmission. The hydrostatic

 

transmissions power a fully enclosed HydroGear gearbox.

ENGINE:

19HP Kawasaki overhead valves, replaceable oil filter, full

 

pressure lube system, dual element air cleaner, integral fuel

 

pump.

 

STARTING SYSTEM: Electric by key switch operation with safety interlocks on

 

parking brake and blade drive clutch.

TIRES:

Front

11 X 4 X 5 ribbed tread

 

Rear

20 X 10 X 8 Multi-Trac

RECOMMENDED

Front

16 - 21 lbs.

TIRE PRESSURE:

Rear

8 - 14 lbs.

CAPACITIES:

Fuel - 4.8 gallons total (dual tanks)

 

Oil tank - 3 quart with in-line 40 micron filter

 

Engine - 2 qts. SAE 30 (with filter)

DIMENSIONS:

Width

55” (42” Deck), 60” (50” Deck)

 

Height

45”

 

Length

72:

 

Weight

594 lbs, (42” Deck], 650 lbs (50” Deck)

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13

Image 13
Contents Series Important Read Carefully Index Safety Warranty PolicyBlade Contact TIP Over RUN Over Back Over SafetySafety Alert Symbol General Operation General Operation Do not Slope OperationNever allow children to operate the mower ChildrenService Service 5000 6000 7000 Series Mowers Dixon Limited Warranty Policy Hydro Gear ModelsSpecifications Model ZTR SpecificationsSeat Adjustment Instructions Control Levers ControlsThrottle Control Lever Choke Control LeverHydro Gear System Parking BrakeTo SET Parking Brake Circuit Breaker Blade DriveMower Deck CUT Height Lift Lever To Free Wheel Machine Unlock Transmission Towing Operation InstructionsBefore Operating Mower Engine should Stop Parking Brake Switch TestSide Discharge of the Clippings Grass Height and Cutting Suggestions Starting Instructions engine has been operated Starting Instructions cold engine Mowing with a Mulching Attachment CUT High MOW Often Mowing with a Mulching AttachmentMowing with a Grass Catcher Attachment Mowing with a Grass Catcher Attachment Deck Rollers 60 deck Maintenance Schedule Care and MaintenanceOFF Season Battery Storage BatteryEngine TiresCutter Blade Maintenance Belt Tension BeltsLubrication Fuel Shut OFF ValveChassis LocationsChanging the Engine OIL OIL Filters OIL FillHydrostatic Transmission OIL & Filter Service Care and Maintenance Recommended OIL Weight Service IntervalsOIL Requirements Warranty Cleaning the MowerPARTS/SERVICE Electrical SystemsMower Deck Leveling Procedure Mower Deck Leveling Procedure Mower Deck Removal BOX to Hydrostat Belt Adjustment Parking Brake Cable Adjustment Wheel Reversal Rear WheelsNeutral Adjustment Neutral Adjustment AIR GAP Adjustment Procedure for Electric Clutch AdjustmentOhms Test Forward Travel Speed Adjustment Troubleshooting Engine Runs but Mower WON’T Move Forward Engine Stalls When Blades are EngagedDrive System CUT QualityDeck Standard Service Parts ListKawasaki and Kohler AIR & OIL Filter Part Numbers Name Address Owner InformationZTRMowers