Dixon 502 Raise rear body cover to fully open position, Flat washer and jam nut. See Illustration

Page 11

Page 8

UPPER CONTROL LEVER INSTALLATION

1.Raise rear body cover to fully open position.

2.Install flat washer on right hand swivel plate weldment. Next install right hand control lever, then second flat washer.

3.Push control lever into the neutral slot and install (2) cup washers,

(1)flat washer and jam nut. (See Illustration)

4.Tighten jam nut. Proper tightness or tension on jam nut is achieved

when swing out movement of upper control levers requires some pressure. Levers should not fall to the side or be sloppy in movement.

5. Repeat above procedure on left side.

Image 11

Contents Page Index Safety Important Read Carefully See your dealer for warranty service, parts and repairsSatisfactory use of this product Always look behind you before backing upSafety Safety Reminders Read Carefully Before Operation Alcohol or drugs Safety RemindersPage Chassis 11 GA rectangular tube Specifications Subject to Change Without NoticeBlade Drive Warner electric clutch SET UP and Service Seat assembly instructionsSeat Assembly Instructions Flat washer and jam nut. See Illustration Repeat above procedure on left sideRaise rear body cover to fully open position Position mower deck under chassis Mower Deck InstallationLeveling the Deck Adjustment PointsLeveling Principals Final Preparation Remove battery from chassisNo shifting or clutching required Sound judgment by the owner will prevent accidentsMower Deck CUT Height Lift Lever Light SwitchOperation Instructions Throttle Control LeverMaintenance Schedule Care and Maintenance ModelBelt Tension Reverse procedure to re-install deck assemblyCutter Blade Removal Repeat above procedures on opposite hydrostat Page Adjustment Points for T-BOX Belt Tension Forward lever stop adjustment Operation Primary and final driveZerks used Each front wheel casterCare and Maintenance Model Cleaning the Mower Reduce mowing speed Trouble Shooting Mower CUT QualityPoor cut quality Improper blades Uneven tire pressuresBox belts slipping Drive adjustmentSide or the other Manual RepairClutch switch Battery Required Battery water lowMower Battery discharge Low battery conditionDeck Assembly Model 5O2 Body Assembly Model BOX and Hydrostats Assembly Model Chassis Assembly Model Fuel & Hydraulics Tanks & Fittings Assembly Model Wiring Assembly Model Fuel Cap/Gauge LH Slide Angle1471 Seat Slide 4216 Battery Ground Cable 5581 4569 Lower Wiring Loom4013 Wire Tie 4199 Light Switch 5577 Drive Chain-SecondarySeat Frame Headlight BulbRear Rim Rear Tire