Dixon 502 manual Blade Drive Warner electric clutch, Chassis 11 GA rectangular tube

Page 8

Page 5

SPECIFICATIONS

Chassis: 11 GA - rectangular tube.

Body: Two piece - made of DR acrylic reinforced with fiberglass, color fast, scratch and impact resistant. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Seat: Economically designed for operator comfort by use of high density closed cell foam, contoured back rest and arm rests. Seat is adjustable fore and aft.

Mower Deck: 12 GA stamped steel construction, (3) blades, 50" cut width, cut height 1" to 4" via 7 position lift handle. Self cleaning design, smoothly curved front, aides discharge of grass.

Blade Drive: Warner electric clutch.

Drive System: (2) Sundstrand BDU - 10 L hydrostatic transmissions driven by a permanently lubricated peerless gear box.

Engine: 18 HP Kohler twin cylinder with cast iron cylinder, pressure lubrication and mechanical fuel pump.

Starting System: Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Tires: Front 11 x 4.10 x 5 smooth tread. Rear 20 x 10 x 8 turf savers.

Capacities: Fuel - 4.8 gallons total (dual tanks) with fuel gauges. Hydrostat oil tank - 3 quart with inline 10 micron filter. Hydrostat oil recommendation - name brand SAE (10-W-30) motor oil.

Dimensions: Width - 60" Height - 45" Length - 72" Weight - 665 lbs.

NOTE: Additional information provided in service instruction under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE........................

Image 8
Contents Page Index Safety See your dealer for warranty service, parts and repairs Important Read CarefullyAlways look behind you before backing up Satisfactory use of this productSafety Safety Reminders Read Carefully Before Operation Safety Reminders Alcohol or drugsPage Chassis 11 GA rectangular tube Specifications Subject to Change Without NoticeBlade Drive Warner electric clutch Seat assembly instructions SET UP and ServiceSeat Assembly Instructions Flat washer and jam nut. See Illustration Repeat above procedure on left sideRaise rear body cover to fully open position Mower Deck Installation Position mower deck under chassisLeveling the Deck Adjustment PointsLeveling Principals Remove battery from chassis Final PreparationSound judgment by the owner will prevent accidents No shifting or clutching requiredLight Switch Operation InstructionsThrottle Control Lever Mower Deck CUT Height Lift LeverCare and Maintenance Model Maintenance ScheduleBelt Tension Reverse procedure to re-install deck assemblyCutter Blade Removal Repeat above procedures on opposite hydrostat Page Adjustment Points for T-BOX Belt Tension Forward lever stop adjustment Primary and final drive Zerks usedEach front wheel caster OperationCare and Maintenance Model Cleaning the Mower Trouble Shooting Mower CUT Quality Poor cut qualityImproper blades Uneven tire pressures Reduce mowing speedDrive adjustment Side or the other ManualRepair Box belts slippingBattery Required Battery water low Mower Battery dischargeLow battery condition Clutch switchDeck Assembly Model 5O2 Body Assembly Model BOX and Hydrostats Assembly Model Chassis Assembly Model Fuel & Hydraulics Tanks & Fittings Assembly Model Wiring Assembly Model Fuel Cap/Gauge LH Slide Angle1471 Seat Slide 4569 Lower Wiring Loom 4013 Wire Tie4199 Light Switch 5577 Drive Chain-Secondary 4216 Battery Ground Cable 5581Headlight Bulb Rear RimRear Tire Seat Frame