Dixon 502 manual Primary and final drive, Zerks used, Each front wheel caster, Operation

Page 23

Page 20

CARE AND MAINTENANCE - MODEL 502

LUBRICATION:

 

 

CHASSIS AND MOWER DECK:

Number of grease

zerks used (2)

LOCATIONS:

(1) each front wheel caster

SERVICE INTERVALS:

Every (50) hours

of operation

RECOMMENDED GREASE:

Name brand wheel

bearing or multi-purpose grease

CAUTION:

The use of compressed air pressure greasing methods

is not recommended as damage to seals and bearings could occur.

Using a hand pressure grease gun, lubricate each front caster to allow even distribution of grease within the caster, rotate or spin each front wheel caster after (3) pumps of the grease gun. Repeat process until the appearance of grease is noted completely around each caster.

DRIVE CHAINS:

Primary and final drive

RECOMMENDED LUBRICANT:

Name brand aerosol chain spray

SERVICE INTERVALS:

As required for operating conditions

Remove excess dirt from chains, lubricate each chain completely by applying the lube to the inside of each connecting link. Applying lube directly to the top of the chain will only allow the lube to be thrown off in operation. The chains are of special construction which use o-rings to seal a factory lubricant inside of the chain. Additional lubrication will cushion chain to sprocket engagement. Avoid the use of any lubricants which may damage the o-rings used on this chain.

ENGINE OIL CHANGES:

"Refer to separate owners manual furnished by the OIL

RECOMMENDATIONS:

engine manufacturer."

SERVICE INTERVALS:

 

Please dispose of used oils at proper collection centers. Protect your environment.

'

•

"

*

•

-

'

"

,

•

"

.

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Page Index Safety Important Read Carefully See your dealer for warranty service, parts and repairsSatisfactory use of this product Always look behind you before backing upSafety Safety Reminders Read Carefully Before Operation Alcohol or drugs Safety RemindersPage Chassis 11 GA rectangular tube Specifications Subject to Change Without NoticeBlade Drive Warner electric clutch SET UP and Service Seat assembly instructionsSeat Assembly Instructions Flat washer and jam nut. See Illustration Repeat above procedure on left sideRaise rear body cover to fully open position Position mower deck under chassis Mower Deck InstallationLeveling the Deck Adjustment PointsLeveling Principals Final Preparation Remove battery from chassisNo shifting or clutching required Sound judgment by the owner will prevent accidentsMower Deck CUT Height Lift Lever Light SwitchOperation Instructions Throttle Control LeverMaintenance Schedule Care and Maintenance ModelBelt Tension Reverse procedure to re-install deck assemblyCutter Blade Removal Repeat above procedures on opposite hydrostat Page Adjustment Points for T-BOX Belt Tension Forward lever stop adjustment Operation Primary and final driveZerks used Each front wheel casterCare and Maintenance Model Cleaning the Mower Reduce mowing speed Trouble Shooting Mower CUT QualityPoor cut quality Improper blades Uneven tire pressuresBox belts slipping Drive adjustmentSide or the other Manual RepairClutch switch Battery Required Battery water lowMower Battery discharge Low battery conditionDeck Assembly Model 5O2 Body Assembly Model BOX and Hydrostats Assembly Model Chassis Assembly Model Fuel & Hydraulics Tanks & Fittings Assembly Model Wiring Assembly Model Fuel Cap/Gauge LH Slide Angle1471 Seat Slide 4216 Battery Ground Cable 5581 4569 Lower Wiring Loom4013 Wire Tie 4199 Light Switch 5577 Drive Chain-SecondarySeat Frame Headlight BulbRear Rim Rear Tire
Top Page Image Contents