Dixon 502 manual Operation Instructions, Throttle Control Lever, Mower Deck CUT Height Lift Lever

Page 16

Page 13

OPERATION INSTRUCTIONS (continued)

THROTTLE CONTROL LEVER:

Controls engine speed. (Engine should be operated at full throttle when use.d in a mowing application, this will insure adequate cooling of the engine as well as maintaining mower deck blade speed) Located on control panel on operators right.

MOWER DECK CUT HEIGHT LIFT LEVER:

Controls the cutting height of the mower deck. Seven positions of adjustment in which the very top, or highest notch, is used for transporting the mower in a non-mowing situation. Located in front of operator on the right side of mower.

BLADE DRIVE:

To engage the mower deck cutter blades, lift switch up lightly and push forward. To disengage blades, pull switch backward. Switch is clearly marked "on and off".

LIGHT SWITCH:

The headlights are activated by pushing the switch forward. Failure to turn off the lights, once the engine is stopped, will result in rapid discharge of the battery.

FUSE BLOCK:

Protection of the electrical system is by (1) 15 AMP fuse. To remove the fuse for inspection, just simply lift upon fuse block lid. If fuse burns quickly, please consult your dealer for inspection and repair. Never attempt to bypass the fuse by any method.

Image 16

Contents Page Index Safety See your dealer for warranty service, parts and repairs Important Read CarefullyAlways look behind you before backing up Satisfactory use of this productSafety Safety Reminders Read Carefully Before Operation Safety Reminders Alcohol or drugsPage Blade Drive Warner electric clutch Specifications Subject to Change Without NoticeChassis 11 GA rectangular tube Seat assembly instructions SET UP and ServiceSeat Assembly Instructions Raise rear body cover to fully open position Repeat above procedure on left sideFlat washer and jam nut. See Illustration Mower Deck Installation Position mower deck under chassisLeveling Principals Adjustment PointsLeveling the Deck Remove battery from chassis Final PreparationSound judgment by the owner will prevent accidents No shifting or clutching requiredLight Switch Operation InstructionsThrottle Control Lever Mower Deck CUT Height Lift LeverCare and Maintenance Model Maintenance ScheduleCutter Blade Removal Reverse procedure to re-install deck assemblyBelt Tension Repeat above procedures on opposite hydrostat Page Adjustment Points for T-BOX Belt Tension Forward lever stop adjustment Primary and final drive Zerks usedEach front wheel caster OperationCare and Maintenance Model Cleaning the Mower Trouble Shooting Mower CUT Quality Poor cut qualityImproper blades Uneven tire pressures Reduce mowing speedDrive adjustment Side or the other ManualRepair Box belts slippingBattery Required Battery water low Mower Battery dischargeLow battery condition Clutch switchDeck Assembly Model 5O2 Body Assembly Model BOX and Hydrostats Assembly Model Chassis Assembly Model Fuel & Hydraulics Tanks & Fittings Assembly Model Wiring Assembly Model 1471 Seat Slide LH Slide AngleFuel Cap/Gauge 4569 Lower Wiring Loom 4013 Wire Tie4199 Light Switch 5577 Drive Chain-Secondary 4216 Battery Ground Cable 5581Headlight Bulb Rear RimRear Tire Seat Frame