Casablanca Fan Company #C18G500FPOMONA owner manual Hanging the Fan, Connecting the Wires

Hanging the Fan

7 Hold the motor housing with both hands. Insert the ball of the downrod into the canopy opening. Check to ensure that the wires are not pinched. Rotate the motor housing until the slot in the downrod ball locks into the pin opposite the canopy opening.

Connecting the Wires

8 Trim the extra length from the motor wires. Be certain to leave at least 6 inches of wire above the downrod. Use a wire stripper (not included) to strip ½-inch of insulation from the end of each trimmed wire.

9 To attach the fan wires to the ceiling fixture wiring, match the wire colors as described below, hold the bare ends of the wires side by side, and fully insert the wires into the wire nut. Secure by rotating the wire nut in a clockwise motion.

Connect wires in the following order:

•GREEN wires from mounting plate and downrod assembly of fan to GROUND wire of power source.

•WHITE fan wire to WHITE neutral wire from ceiling outlet box.

•BLACK power wire from fan to BLACK power wire in ceiling outlet box.

•BLUE D1 optional fan wire to RED power wire (second hot wire) in ceiling outlet box.

NOTE: If the colors of your wiring differ from that described, consult an electrician.

Inspect each wire nut to ensure that no bare wire is visible. Test the connection by gently pulling on the wires. The wire nuts should stay firmly in place, covering the bare ends.

Step 7

Ball

Slot

Pin

Steps 8-9

RED and

BLUE wires

2 BLACK wires

2 WHITE wires

3 GREEN wires

Wire nut