Casablanca Fan Company #C18G500FPOMONA Installing the Light Fixture, Attaching the Light Fixture

Atria™

Installing the Light Fixture

Hardware (not to scale)

Light Fixture (1) Light Fixture Screws (2) Halogen Downlight Bulbs, 50W (2) Glass Shade (1)

Light Kit Cap and Finial (1 set)

Attaching the Light Fixture

1 Locate and remove the pre-installed wire nuts on the motor housing wires.

2 To attach the light fixture wires to the motor housing wires, match the wire colors as described below, hold the bare ends of the wires side by side, and fully insert the wires into the wire nut. Secure by rotating the wire nut in a clockwise motion.

Connect wires in the following order:

•WHITE wire from the fan to the WHITE wire from the light fixture

•BLUE wire from the fan to the BLUE wire from the light fixture

Inspect each wire nut to ensure that no bare wire is visible. Test the connection by gently pulling on the wires. The wire nuts should stay firmly in place, covering the bare ends.

3 Carefully coil or tuck the wires so they are not pinched. Locate the four mounting holes in the light fixture and align the four holes of the light fixture to motor housing with the two screws pre-installed on the motor housing. Then rotate the light fixture clockwise, locking it to the bottom of the fan. Once the light fixture has been mounted to the bottom of the fan as shown in Step 3, install the remaining two screws, then tighten all four screws with the provided screwdriver.

Steps 1-2

WHITE wire

from fan

WHITE wire from light

fixture

Step 3

Light fixture screws (2)

BLUE wire

from fan

BLUE wire from light fixture

19