Casablanca Fan Company #C18G500FPOMONA owner manual Installing the Mounting Hardware, Assembling

Assembling

1Prepare the ceiling fixture outlet box for the lag screw by removing the plug in the center. If the outlet box does not have a plug, drill a ½-inch hole in the center of the box. After drilling a hole in the outlet box, drill a ¼-inch hole 3 inches deep into the joist used to support the fan.

Attaching the Crossbar Mounting Bracket

2 To install the crossbar mounting bracket, route the outlet box wires along side of the crossbar mounting bracket. Attach the crossbar mounting bracket to the outlet box with the set of two round-head screws and washers. Use caution when installing the screws and washers. Do not pinch the outlet box wires in the washers.

ÑÑCAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with an approved outlet box (not included) to install the crossbar mounting bracket.

3 Pass the lag screw through the center hole in the crossbar mounting bracket and the ceiling fixture outlet box. Secure the lag screw into the guide hole in the joist, tightening until the outlet box and mounting bracket are mounted firmly to the support beam.

Steps 3-4

Joist

Ceiling wiring

GREEN ground wire

Ceiling fixture

outlet box

(ceiling fan rated)

Crossbar mounting

bracket

(ridge side down)

Washers (2)

1” x 8-32 Round- Head screws (2)

Lag screw and

washer (1)