Black & Decker NPP2018 Chart for Minimum Wire Size Awgof Extension Cords, Nameplate Rating Amps 0

Page 6

capacity than 18 gauge. When using more than one extension to

make up the total length, be sure each extension contains at least

the minimum wire size.

 

 

 

CHART FOR MINIMUM WIRE SIZE (AWG)OF EXTENSION CORDS

 

NAMEPLATE RATING AMPS – 0 – 10.0

 

Total Extension Cord

26-50

51-100

101-150

Length (ft)

0-25

Wire Gauge

(0-7,6m)

(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

18

16

16

14

9. Use only the supplied charger when charging your unit. The use of any other charger could damage the battery pack or create a hazardous condition.

10. Use only one charger when charging.

11. Do not attempt to open the charger or the unit. There are no customer serviceable parts inside. Return to any authorized Black & Decker service center.

12. DO NOT incinerate battery packs even if they are severely damaged or completely worn out.

13. Do not incinerate the batteries. They can explode in a fire. A small leakage of liquid from the battery cells may occur under extreme usage, charging or temperature

conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical

attention.The liquid is a 25-35% solution of potassiumMEDICALhydroxide.NOTE:

IMPORTANTCHARGINGSAFETY

INSTRUCTIONS

CHARGING PROCEDURE

 

THE BATTERY PACK IS NOT FULLYCHARGED AT THE

 

FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS

 

The charger is designed to use standard household 120 volt 60 Hz

 

BEFORE USE.

 

 

power.

 

 

1. Plug the charger into any standard 120 Volt 60 Hz electrical

 

outlet. NOTE: Do not charge by means of an engine

 

generator or DC power source. Use only 120V AC.

 

2. Slide the charger onto the battery as

1

 

shown in figure 1 and let the battery

 

 

charge initially for 9 h urs. After the

 

 

initial charge, under normal usage, your

 

 

battery should be fully charged in 6 to 9

 

 

2a) During charging the green LED will

 

 

hours.

 

 

appear.

 

 

2b) When charging is complete the green

 

 

LED will go off.

 

 

3. Unplug charger, and remove the battery pack. Place the battery

 

NOTE: To remove the battery pack, press down on the release

 

pack into the t ol until it “clicks” into place.

 

button on the back of the battery pack and slide out.

 

IMPORTANT CHARGING NOTES

 

 

1. After normal usage, your battery pack should be fully charged in

 

6 to 9 hours. If the battery pack is run-down completely, it may

 

take up to 9 hours to become fully charged. Your battery pack

 

was sent from the factory in an uncharged condition. Before

 

attempting to use it, it must be charged for at least 9 hours.

6

2. DO NOT charge the battery pack in an air temperature below

 

 

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Cordless Pole Saw Do not operate Pole Saw General Safety Rules Pinch or fall into chainKickback Safety Features To filter out microscopic particlesSkinand mayw terpromote. absorption of harmful chemicals Battery Cap Inform Tion Battery in charger or toolCharging Nameplate Rating Amps 0 Chart for Minimum Wire Size Awgof Extension CordsGenerator or DC power source. Use only 120V AC Outlet. Note Do not charge by means of an engineLeaving the Battery Pack in the Charger Storage RecommendationAnd/or serious personal injury Installing and Removing Saw ChainSlot is located over the adjustment Pin Could result in serious personal injuryChain Oiling Adjusting Chain TensionChain with graphic on housing shown here Transporting Pole SawSlide the threaded sleeve 6 figure Joining Saw Head Module to 18V Handle ModuleToattach the handle module to the saw head module Becoming disconnected creating a hazardous conditionDetaching Saw Head Module Connecting the BatterySwitch Auto-Stop Chain Braking SystemPruning With the Pole Saw Problem Possible Cause Possible Solution AccessoriesTroubleshooting Section Saw chain sharpnessPossible Cause Possible Solution Troubleshooting Section Con’tProblem See ʻTools-ElectricʼScie à long manche sans fil Consignes DE Securite Importantes Pendant lʼutilisation de la scie à long mancheDispositif de protection contre les rebonds EntretienNe pas utiliser la scie à long manche Règles de sécurité GénéralitésTenir lʼoutil par les surfaces isolées prévues à cet effet En contact avec des fils électriques cachés ou son propreAvertissement risque d’incendie. Ne pas ranger ni ne Pile Lutilisation dun accessoire non recommandé ni vendu parLa sûreté et au fonctionnement Mise EN Garde Afin de minimiser les risques de120 V, 60 Hz. Remarque Ne chargez pas la batterie au Le chargeur est conçu pour être branché dans une priseRésidentielle standard de 120 volts et de 60 Hz Moyen dun alternateur ou dune source dalimentation c.cRanger loutil Recommandations DʼENTREPOSAGEGlossaire terminologique de la scie à long manche Ensemble DE Piles Dans LE ChargeurInstallation et retrait de la chaîne coupante CaractéristiquesUtilisation Assemblage Graissage de la chaîneRéglage de la tension de la chaîne Assemblage du module de tête deDémontage Pour détacher le module de tête de scie Assemblage du module central avec le module deTête de scie et le module de poignée Pour prévenir tout accident, sʼassurer quela pile est bienInterrupteur Utilisation de la scie à long mancheBranchement de la pile Système de freinage dʼarrêt automatiqueÉbranchage avec la scie à long manche Affûtage de la chaîne coupante AccessoiresGuide de dép nnage Entretien de la scie à long mancheProblème Cause probable Solution possible Manual DE Instrucciones Reglas Importantes DE Seguridad Al operar la garrocha podadoraProtector contra rebote No opere la garrocha podadoraServicio PrecaucionesNormas específicas de seguridad Piel expuestas con agua y jabón. Si permite que el polvo se Información sobre el protector de la bateríaSerruchado, pulido y taladrado mecánico y otras actividades Advertencia La utilización de esta herramienta puedeTabla DE Medidas Minimas DE Conductor AWG Para Amperios Segun Placa 0 aCarga DE AL Menos 9 Horas Antes DE SU USO Paquete DE Bateríasno Vienen CompletamenteCargadas DE FÁBRICA. Paquete DE Baterías DE Recomendacion Para EL AlmacenamientoNombres y terminología para la garrocha podadora Dejando LA Batería EN EL CargadorBarra guía de rebote reducido Una barra guía que se ha Características Instalación y desmantelamiento de la cadena de laSierra Ajuste de la tensión de la cadena Aceitado de la cadenaTransporte de la garrocha podadora Advertencia Siempre revise Con el saliente de la parte interna delLo más que pueda y enrosque el 40 módulos para verificar que no se vean hilos naranjosConexión de la batería Desmantelamiento Separación del módulo de la sierraOperación de la garrocha Podadora ConmutadorPoda con la Para podar con la garrocha podadoraAdvertencia Tensión de la cadena de la sierra AccesoriosSección de resolución de problemas Causa posible Posible solución ProblemaProblema Causa posible Posible solución Epecificaciones NPP2018 Page Product Infomation · Identificacion DEL Producto Form No June Cat No. NPP2018 Copyright 2011 Black & Decker
Related manuals
Manual 44 pages 39.07 Kb

NPP2018 specifications

The Black & Decker NPP2018 is a powerful and innovative outdoor tool designed for homeowners who want to maintain their yards with ease and efficiency. This electric pole saw features an 18-volt lithium-ion battery that delivers impressive cutting performance while providing the convenience of being cordless. With a lightweight design and user-friendly features, the NPP2018 is ideal for trimming branches, pruning trees, and tackling tough overgrown areas.

One of the standout features of the Black & Decker NPP2018 is its extendable reach. The telescoping pole allows for an adjustable length, extending up to 10 feet, enabling users to access hard-to-reach branches without the need for a ladder. This not only enhances safety but also makes it easier to complete tasks without additional assistance.

The saw is equipped with a 10-inch Oregon bar and chain, which offers efficient cutting and reduced kickback, allowing for smooth operation. The automatic oiling system ensures that the bar and chain are constantly lubricated, significantly extending the tool’s life and maintaining optimal cutting performance. This technology reduces the time and effort required for maintenance, allowing users to focus more on the job at hand.

Additionally, the NPP2018 features a lightweight construction, weighing approximately 6.5 pounds, which enhances portability and maneuverability. The ergonomic handle design provides a comfortable grip and minimizes user fatigue, making it easier to operate for extended periods.

Black & Decker also emphasizes safety with the NPP2018, incorporating a protective sheath for the blade and an easy-to-use safety switch to prevent accidental starts. These features promote secure operation, especially for inexperienced users or those unfamiliar with power tools.

In summary, the Black & Decker NPP2018 is a versatile and effective tool for any homeowner looking to manage their outdoor spaces. With its powerful lithium-ion battery, extendable reach, automatic oiling system, and ergonomic design, this pole saw represents an innovative solution for tackling tree pruning and branch trimming tasks efficiently and safely. Whether you are a gardening novice or a seasoned pro, the NPP2018 delivers the durability and performance needed for effective yard maintenance.
Top Page Image Contents