Blue Rhino 163010 owner manual Connect Engine/Post Assembly to Cap, Connect Gas Line to Engine

Page 10

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Step 8 – Connect Engine/Post Assembly to Cap

•Insert end of Post with (4) holes not threaded over Gas Line

•Line up Post holes with threaded Cap holes.

•Loosely Secure Post to Cap, using (4) Medium Screws, fully tighten screws in Step 9.

Step 9 – Connect Gas Line to Engine

•To attach Gas Line to Control Valve:

•Pull collar of Gas Line down.

•Insert Gas Line over Control Valve.

•Release Gas Line Collar and it should lock in place. (Tip – push Gas Line up from bottom of Post to make a good seating before

releasing Collar.)

•Gently tug on line to test for proper connection. If Gas Line moves you are not properly connected.Do not proceed until a proper connection has been made.

•After gas line is secure, fully tighten (4) screws from Step 8.

Step 10 – Attach Dome to Emitter

• Gently lay heater on its side

Tip: Use styrofoam end to prop up top half of heater.

• Align holes in Dome with Emitter Studs.

• Secure Dome to Emitter using (3) Cap Nuts.

• Leave heater on its side for next step.

9

Owner’s manual and assembly instructions: model 163010 natural gas outdoor patio heater

12/4/02

Image 10

Contents Manuel d’Utilisation 12/4/02 12/4/02 Safety First For Your SafetyFor Your Safety Picture Qty Additional Requirements General Components & FeaturesAttach Legs to Base Attach Cylinder Shroud to Legs Attach Cap Assembly to Legs/Insert Gas LineAssemble Cup, Plate & Ring to Cap Assemble Emitter Assemble Emitter TopAttach Engine to Post Connect Gas Line to Engine Connect Engine/Post Assembly to CapAttach Dome to Emitter Check for Leaks Secure Gas LineCheck Gas Line / Cylinder valve for leaks Install Cylinder Access Panel Replace Engine Access PanelBefore Lighting Before Turning Gas Supply onLighting Re-lighting When heater is onShut Down Before Operating After OperationIf the problem is This condition exists Then do this TIP During periods of extended inactivity or when transporting ServiceBetween uses Warranty Period Rating Safety FeaturesCertifications Heat Range12/4/02 Avertissement Table des matières La sécurité avant tout Section La sécurité avant toutPour Votre Sécurité Bonbonne de gaz de 9 kgPièces QuincaillerieInstructions de montage Accessoires SupplémentairesÉtape 1 Fixer les jambes au socle Conseil Étape 6 Assembler l’émetteur Étape 7 Fixer le moteur au pôleÉtape 9 Raccorder la conduite de gaz au moteur Étape 10 Fixer le dôme à l’émetteurÉtape 15 Rechercher une fuite potentielle Étape 11 Fixer la conduite de gazVérifier la conduite de gaz et la bonbonne Étape 14 Installer le panneau d’accès de la bonbonne Étape 15 Replacer le panneau d’accès du moteurAvant d’allumer l’appareil Avant d’ouvrir la commande de gaz onFonctionnement Allumer l’appareilRallumer l’appareil Lorsque l’appareil est allumé onÉteindre l’appareil Vérifications à effectuer avant toute utilisation Après toute utilisationGuide de dépannage Dans le cas suivant Problème Pour corriger le problèmeEntretien Rangement Service après-venteEntre chaque utilisation Garantie Période de garantieCaractéristiques techniques Page NASDAQ-RINO